The effects of buoyancy on the flow regimes of submerged gas injection were studied in this investigation. A capillary tube submerged in water was used for gas injection in microgravity and terrestrial conditions, and the resulting flow regimes and bubble sizes were documented. The effects of liquid co-flow and reduced surface tension were also analyzed. Under reduced gravity, three flow regimes were observed over the range of conditions tested. At low gas flow rates, the bubbles did not detach from the injector, forming an interconnected bubble cluster that adhered to the injector. Single bubbles started detaching and moving away from the injector when the Weber number reached a value around 3. At gas flow rates corresponding to a Weber number value of 10, the bubble coalescence regime was observed near the injector. It was found that the absence of buoyancy prevented the formation of the jetting regime. For all gas throughputs, the co-flowing liquid aided the detachment of the bubbles, resulting in the generation of more uniform bubbles than in quiescent liquids. The presence of co-flow resulted in a smaller bubble size accompanied by an increased frequency of bubble formation. Reduced surface tension produced a similar effect, resulting in smaller bubbles.
Skip Nav Destination
ASME 2002 Engineering Technology Conference on Energy
February 4–5, 2002
Houston, Texas, USA
Conference Sponsors:
- Petroleum Institute
ISBN:
0-7918-3591-X
PROCEEDINGS PAPER
Submerged Gas Injection in Microgravity
R. N. Parthasarathy,
R. N. Parthasarathy
University of Oklahoma, Norman, OK
Search for other works by this author on:
S. R. Gollahalli
S. R. Gollahalli
University of Oklahoma, Norman, OK
Search for other works by this author on:
J. Carrera
University of Oklahoma, Norman, OK
R. N. Parthasarathy
University of Oklahoma, Norman, OK
S. R. Gollahalli
University of Oklahoma, Norman, OK
Paper No:
ETCE2002/CAE-29009, pp. 29-35; 7 pages
Published Online:
January 7, 2009
Citation
Carrera, J, Parthasarathy, RN, & Gollahalli, SR. "Submerged Gas Injection in Microgravity." Proceedings of the ASME 2002 Engineering Technology Conference on Energy. Engineering Technology Conference on Energy, Parts A and B. Houston, Texas, USA. February 4–5, 2002. pp. 29-35. ASME. https://doi.org/10.1115/ETCE2002/CAE-29009
Download citation file:
6
Views
Related Proceedings Papers
Related Articles
Filling Process in an Open Tank
J. Fluids Eng (November,2003)
Heater Size and Gravity Based Pool Boiling Regime Map: Transition Criteria Between Buoyancy and Surface Tension Dominated Boiling
J. Heat Transfer (September,2010)
A Look on Fang Number
J. Heat Transfer (June,2014)
Related Chapters
Piping Design
Power Boilers: A Guide to the Section I of the ASME Boiler and Pressure Vessel Code, Second Edition
Small Raindrops
Case Studies in Fluid Mechanics with Sensitivities to Governing Variables
Buoyancy Control at Water Crossings and Overland
Pipeline Geohazards: Planning, Design, Construction and Operations