The air pressure drop over the nozzles manifolds of inlet fogging system and the flow resistance downstream of the nozzle array (manifold) have always been an area of concern and is the object of this paper. Fogging nozzles arrays (involving several hundred nozzles) are mounted on channels and beams, downstream of the inlet filters and affect the pressure drop. The water injection angle, nozzle injection velocities and the progressive evaporation of the water droplets evaporation all influence the inlet pressure seen at the gas turbine inlet. This paper focuses on a numerical simulation investigation of flow resistance (pressure drop) of inlet fogging systems.

In this research effort, the inlet duct is meshed in order to compute the pressure drop over the nozzles frames in fogging and non-fogging conditions. First, the resistance coefficients of an air intake filter are obtained by numerical and experimental methods, and then the coefficients are used for the simulation of the inlet duct by considering the filter as a porous media. Effects of nozzle spread pattern and water injection pattern are then modeled. The results indicate that injection velocity and arrangement of nozzles could have significant effects on the pressure drop and intake distortion, which will affect compressor performance. This paper provides a comprehensive analysis of the pressure drop and evaporation of inlet fogging and will be of value to gas turbine inlet fogging system designers and users.

This content is only available via PDF.
You do not currently have access to this content.