1-6 of 6
Keywords: Rotation
Close
Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Proceedings Papers

Proc. ASME. GT2021, Volume 5B: Heat Transfer — General Interest; Internal Air Systems; Internal Cooling, V05BT15A022, June 7–11, 2021
Paper No: GT2021-60182
... turbine blade cooling two-pass channel cross bridge dimple rotation heat transfer Proceedings of ASME Turbo Expo 2021 Turbomachinery Technical Conference and Exposition GT2021 June 7-11, 2021, Virtual, Online GT2021-60182 ROTATING COOLING PERFORMANCE OF TWO-PASS RECTANGULAR CHANNELS...
Proceedings Papers

Proc. ASME. GT2020, Volume 7B: Heat Transfer, V07BT12A034, September 21–25, 2020
Paper No: GT2020-14836
... University, Beijing, China ABSTRACT Numerical simulations were carried out to study the film cooling effectiveness distributions of different hole arrangements on the suction side of a high pressure turbine blade under rotating condition. The chord length and the height of the blade are 60mm and 80mm...
Proceedings Papers

Proc. ASME. GT2019, Volume 2C: Turbomachinery, V02CT41A028, June 17–21, 2019
Paper No: GT2019-91353
..., simulations are carried out with forced rotating vaneless diffuser. It gives better results in terms of pressure rise with lower stagnation pressure losses. But there is a moderate decrement in isentropic efficiency of compressor when compared to the base model. vaneless diffuser pinching rotation...
Proceedings Papers

Proc. ASME. GT2010, Volume 4: Heat Transfer, Parts A and B, 555-567, June 14–18, 2010
Paper No: GT2010-23510
... improvement versus pressure drop penalty. The system rotates about an axis orthogonal to its centreline. The configuration was analyzed with the planar two-component PIV technique (2C PIV), which is capable of obtaining complete maps of the instantaneous as well as the averaged flow field even at high levels...
Proceedings Papers

Proc. ASME. GT2008, Volume 4: Heat Transfer, Parts A and B, 1039-1050, June 9–13, 2008
Paper No: GT2008-51183
... A) and an asymmetric manner (case B), respectively. The ribs are inclined with an angle of 45 degrees versus the duct axis (i.e. main flow direction). The applied rib lay-out is well-proved and optimized with respect to heat transfer improvement and the inherent pressure drop increase. The system rotates about an axis...
Proceedings Papers

Proc. ASME. GT2006, Volume 3: Heat Transfer, Parts A and B, 1041-1053, May 8–11, 2006
Paper No: GT2006-91245
... process. For rotation number RN = 0 the velocity down each hole remains almost constant. A correlation between hole discharge coefficient and Velocity Head Ratio is also presented. Pressure loss coefficients in the passage and through the holes are also discussed. A High Pressure (HP) rig was tested...