The effects of injection angle on the spray dynamics, combustion process and soot emission were studied. Two different fuels, diesel and biodiesel, were tested on a DIATA optical engine by performing numerical simulation using the modified KIVA III V2. Simulations under three different injection angles and two different injection pressures were performed. The model was verified by comparing the spray penetrations and pressure traces with the experimental measurements. The simulation results show that lower injection pressure strengthens spray operation, and longer ignition delay and lower peak combustion pressure and peak heat release rate are observed. Injection angle of 110° produces the highest peak combustion pressure and heat release rate for diesel fuel. Unlike diesel combustion, the peak combustion pressure and heat releases rate for biodiesel increases as the spray angle narrows. Soot located in the squish or the regions above the piston bowl are readily oxidized due to abundance of oxygen. Portions of fuel are burnt in the region about the piston bowl or squish for both spray angle of 150° and 70°. Soot located within the piston bowl is oxidized at a much slower rate due to deficient oxygen after combustion. Soot emission mainly due to soot within in the piston bowl at the end of combustion. Any strategy that pushes soot out of piston can improve the oxidization process, thus, reducing soot emission. Extra oxygen in biodiesel also helps in reducing the emission. Biodiesel has longer ignition delay over diesel for initial injection. Ignition delay for main injection is negligible in all the cases studied due to the cylinder condition upon main injection. Soot emissions are reduced from biodiesel blends and this is consistent with the general observation.
- Internal Combustion Engine Division
The Effects of Spray Angles on Spray Combustion of Diesel and Biodiesel in Diesel Engines
- Views Icon Views
- Share Icon Share
- Search Site
Shen, C, Cheng, WL, & Lee, CF. "The Effects of Spray Angles on Spray Combustion of Diesel and Biodiesel in Diesel Engines." Proceedings of the ASME 2014 Internal Combustion Engine Division Fall Technical Conference. Volume 2: Instrumentation, Controls, and Hybrids; Numerical Simulation; Engine Design and Mechanical Development; Keynote Papers. Columbus, Indiana, USA. October 19–22, 2014. V002T06A013. ASME. https://doi.org/10.1115/ICEF2014-5647
Download citation file: