An analysis of the frictional mechanics of a steadily rotating belt drive is carried out using a physically appropriate creep-rate-dependent friction law. Unlike in belt-drive mechanics analyzed using a Coulomb friction law, the current analysis predicts no adhesion zones in the belt-pulley contact region. Regardless of this finding, for the limiting case of a creep-rate law approaching a Coulomb law, all predicted response quantities (including the extent of belt creep on each pulley) approach those predicted by the Coulomb law analysis. Depending on a slope parameter governing the creep-rate profile, one or two sliding zones exist on each pulley, which together span the belt-pulley contact region. Closed-form expressions are obtained for the tension distribution, the sliding-zone arc magnitudes, and the frictional and normal forces per unit length exerted on the belt. A sample two-pulley belt drive is analyzed further to determine its pulley angular velocity ratio and belt-span tensions. Results from this analysis are compared to a dynamic finite element solution of the same belt drive. Excellent agreement in predicted results is found. Due to the presence of arbitrarily large system rotations and a numerically friendly friction law, the analytical solution presented herein is recommended as a convenient comparison test case for validating friction-enabled dynamic finite element schemes.
Analysis of Belt-Driven Mechanics Using a Creep-Rate-Dependent Friction Law
Contributed by the Applied Mechanics Division of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS for publication in the ASME JOURNAL OF APPLIED MECHANICS. Manuscript received by the Applied Mechanics Division, May 30, 2001; final revision, Sept. 25, 2001. Associate Editor: R. C. Benson. Discussion on the paper should be addressed to the Editor, Prof. Robert M. McMeeking, Chair, Department of Mechanics and Environmental Engineering, University of California–Santa Barbara, Santa Barbara, CA 93106-5070, and will be accepted until four months after final publication in the paper itself in the ASME JOURNAL OF APPLIED MECHANICS.
- Views Icon Views
- Share Icon Share
- Search Site
Leamy, M. J., and Wasfy, T. M. (October 31, 2002). "Analysis of Belt-Driven Mechanics Using a Creep-Rate-Dependent Friction Law ." ASME. J. Appl. Mech. November 2002; 69(6): 763–771. https://doi.org/10.1115/1.1488663
Download citation file: