The combination of decentralized control and networked control where control loops are closed through a network is called decentralized networked control system (DNCS). This paper introduces a general framework that converts a generic decentralized control configuration of non-networked systems to the general setup of networked control systems (NCS). Two design methods from the literature of decentralized control for non-networked systems were chosen as a base for the design of a controller for the networked systems, the first being an observer-based decentralized control, while the second is the well-known Luenberger combined observer–controller. The main idea of our design is to formulate the DNCS in the general form and then map the resulting system to the general form of the NCS. First, a method for designing decentralized observer-based controller is discussed. Second, an implementation using a network is analyzed for the two designs. Third, two methods to analyze the stability of the DNCS are also introduced. Fourth, perturbation bounds for stability of the DNCS have been derived. Finally, examples and simulation results are shown and discussed.
Skip Nav Destination
Article navigation
Research-Article
Decentralized Control Framework and Stability Analysis for Networked Control Systems
Ahmed Elmahdi,
Ahmed Elmahdi
School of Aeronautics and Astronautics,
e-mail: aelmahdi@purdue.edu
Purdue University
,West Lafayette, IN 47906
e-mail: aelmahdi@purdue.edu
Search for other works by this author on:
Ahmad F. Taha,
Ahmad F. Taha
School of Electrical
and Computer Engineering,
e-mail: tahaa@purdue.edu
and Computer Engineering,
Purdue University
,West Lafayette, IN 47906
e-mail: tahaa@purdue.edu
Search for other works by this author on:
Dengfeng Sun,
Dengfeng Sun
Assistant Professor
School of Aeronautics and Astronautics,
e-mail: dsun@purdue.edu
School of Aeronautics and Astronautics,
Purdue University
,West Lafayette, IN 47907
e-mail: dsun@purdue.edu
Search for other works by this author on:
Jitesh H. Panchal
Jitesh H. Panchal
Assistant Professor
School of Mechanical Engineering,
e-mail: panchal@purdue.edu
School of Mechanical Engineering,
Purdue University
,West Lafayette, IN 47907
e-mail: panchal@purdue.edu
Search for other works by this author on:
Ahmed Elmahdi
School of Aeronautics and Astronautics,
e-mail: aelmahdi@purdue.edu
Purdue University
,West Lafayette, IN 47906
e-mail: aelmahdi@purdue.edu
Ahmad F. Taha
School of Electrical
and Computer Engineering,
e-mail: tahaa@purdue.edu
and Computer Engineering,
Purdue University
,West Lafayette, IN 47906
e-mail: tahaa@purdue.edu
Dengfeng Sun
Assistant Professor
School of Aeronautics and Astronautics,
e-mail: dsun@purdue.edu
School of Aeronautics and Astronautics,
Purdue University
,West Lafayette, IN 47907
e-mail: dsun@purdue.edu
Jitesh H. Panchal
Assistant Professor
School of Mechanical Engineering,
e-mail: panchal@purdue.edu
School of Mechanical Engineering,
Purdue University
,West Lafayette, IN 47907
e-mail: panchal@purdue.edu
Contributed by the Dynamic Systems Division of ASME for publication in the JOURNAL OF DYNAMIC SYSTEMS, MEASUREMENT, AND CONTROL. Manuscript received February 20, 2014; final manuscript received August 28, 2014; published online December 10, 2014. Assoc. Editor: M. Porfiri.
J. Dyn. Sys., Meas., Control. May 2015, 137(5): 051006 (11 pages)
Published Online: May 1, 2015
Article history
Received:
February 20, 2014
Revision Received:
August 28, 2014
Online:
December 10, 2014
Citation
Elmahdi, A., Taha, A. F., Sun, D., and Panchal, J. H. (May 1, 2015). "Decentralized Control Framework and Stability Analysis for Networked Control Systems." ASME. J. Dyn. Sys., Meas., Control. May 2015; 137(5): 051006. https://doi.org/10.1115/1.4028789
Download citation file:
Get Email Alerts
Design of Attack Resistant Robust Control Based on Intermediate Estimator Approach for Offshore Steel Jacket Structures
J. Dyn. Sys., Meas., Control (September 2025)
Motion Control Along Spatial Curves for Robot Manipulators: A Noninertial Frame Approach
J. Dyn. Sys., Meas., Control (September 2025)
Associate Editor's Recognition
J. Dyn. Sys., Meas., Control (July 2025)
Related Articles
High-Precision Control for Magnetically Suspended Rotor of a DGMSCMG Based on Motion Separation
J. Eng. Gas Turbines Power (July,2015)
Modeling and Control of Electrostatically Actuated MEMS in the Presence of Parasitics and Parametric Uncertainties
J. Dyn. Sys., Meas., Control (November,2007)
Reliable Dissipative Sampled-Data Control for Uncertain Systems With Nonlinear Fault Input
J. Comput. Nonlinear Dynam (July,2016)
A Global Approach to Vehicle Control: Coordination of Four Wheel Steering and Wheel Torques
J. Dyn. Sys., Meas., Control (December,1994)
Related Proceedings Papers
Related Chapters
Auto-Tuning Method of PIDA Controller Based Ongain Margin and Phase Margin
International Conference on Mechanical Engineering and Technology (ICMET-London 2011)
Research on Autobody Panels Developmental Technology Based on Reverse Engineering
International Conference on Advanced Computer Theory and Engineering, 5th (ICACTE 2012)
An Intelligent Control System Based on FPGA for Telephone Communication Network
International Conference on Electronics, Information and Communication Engineering (EICE 2012)