Two-phase flow of oil and water is commonly observed in wellbores, and its behavior under a wide range of flow conditions and inclination angles constitutes a relevant unresolved issue for the petroleum industry. Among the most significant applications of oil-water flow in wellbores are production optimization, production string selection, production logging interpretation, down-hole metering, and artificial lift design and modeling. In this study, oil-water flow in vertical and inclined pipes has been investigated theoretically and experimentally. The data are acquired in a transparent test section (0.0508 m i.d., 15.3 m long) using a mineral oil and water (ρow = 0.85, μow = 20.0 & σo−w = 33.5 dyne/cm at 32.22°C). The tests covered inclination angles of 90, 75, 60, and 45 deg from horizontal. The holdup and pressure drop behaviors are strongly affected by oil-water flow patterns and inclination angle. Oil-water flows have been grouped into two major categories based on the status of the continuous phase, including water-dominated and oil-dominated flow patterns. Water-dominated flow patterns generally showed significant slippage, but relatively low frictional pressure gradients. In contrast, oil-dominated flow patterns showed negligible slippage, but significantly large frictional pressure gradients. A new mechanistic model is proposed to predict the water holdup in vertical wellbores based on a drift-flux approach. The drift flux model was found to be adequate to calculate the holdup for high slippage flow patterns. New closure relationships for the two-phase friction factor for oil-dominated and water-dominated flow patterns are also proposed.

1.
Aguilera, R., Artindale, J. S., Cordell, G. M., Ng, M. C., Nicholl, G. W., and Runions, G. A., 1991, Horizontal Wells, Gulf Publishing Company, Houston, TX, pp. 101–102.
2.
Curtis, M. R., 1967, “Flow Analysis in Producing Wells,” Paper SPE 1908, presented at the 42nd. SPE Annual Fall Meeting, Houston, TX.
3.
Davarzani, J., Sloan, M. L., and Roesner, R. E., 1985, “Research on Simultaneous Production Logging Instruments in Multiphase Flow Loop,” Paper SPE 14431, presented at the 60th. SPE Annual Technical Conference and Exhibition, Las Vegas, NV.
4.
Ding, Z. X., Anderson, C., and Ma, T. A., 1992, “Production Logging Interpretation Techniques: Past and Future,” Paper II, presented at the 33th. SPWLA Annual Logging Symposium, Oklahoma City, OK.
5.
Flexhaug, L. A., 1983, “Production Profiles on Deviated Multi-Phase Producers,” Paper 83-34-40, presented at the 34th Annual Technical Meeting of the Petroleum Society of CIM, Banff, Canada.
6.
Flores, J. G., 1997, “Oil-Water Flow in Vertical and Deviated Wells,” Ph.D. dissertation, University of Tulsa, Tulsa, OK.
7.
Flores, J. G., Chen, X. T., Sarica, C., and Brill, J. P., 1997, “Characterization of Oil-Water Flow Patterns in Vertical and Deviated Wells,” Paper SPE 38810, presented at the 1997 SPE Annual Fall Meeting, San Antonio, TX.
8.
Govier, G. W., Sullivan, G. A., and Wood, R. K., 1961, “The Upward Vertical Flow of Oil-Water Mixtures,” The Canadian Journal of Chemical Engineering, pp. 67–75.
9.
Halford, F. R., MacKay, S., Barnett, S., and Petler, J. S., 1996, “A Production Logging Measurement of Distributed Local Phase Holdup,” Paper SPE 35556, presented at the European Production Operations Conference and Exhibition, Stavanger, Norway.
10.
Harmathy
T. Z.
,
1990
, “
Velocity of Large Drops and Bubbles in Media of Infinite or Restricted Extent
,”
AIChE Journal
, Vol.
6
, No.
2
, pp.
281
288
.
11.
Hasan, A. R., and Kabir, C. S., 1990, “A New Model for Two-Phase Oil/Water Flow: Production Log Interpretation and Tubular Calculations,” SPE Production Engineering, pp. 193–199.
12.
Hill, A. D., and Oolman, T., 1982, “Production Logging Tool Behavior in Two-Phase Inclined Flow,” JPT, pp. 2432–2440.
13.
Hill, A. D., 1990, Production Logging-Theoretical and Interpretive Elements, SPE, Monograph 14, Richardson, TX, pp. 81–111.
14.
Mukherjee
H.
,
Brill
J. P.
, and
Beggs
H. D.
,
1981
, “
Experimental Study of Oil-Water Flow in Inclined Pipes
,”
ASME JOURNAL OF ENERGY RESOURCES TECHNOLOGY
, Vol.
103
, pp.
56
66
.
15.
Nicolas, Y., and Witterholt, E. J., 1972, “Measurements of Multi-Phase Fluid Flow,” Paper SPE 4023, presented at the 47th. SPE Annual Fall Meeting, San Antonio, TX.
16.
Piers, G. E., Perkins, J., and Escott, D., 1987, “A New Flowmeter for Production Logging and Well Testing,” Paper SPE 16819, presented at the 62nd. SPE Annual Technical Conference and Exhibition, Dallas, TX.
17.
Roesner, R. E., LeBlanc, A. J., and Davarzani, M. J., 1988, “Effects of Flow Regimes on Production Logging Instruments’ Responses,” Paper SPE 18206, presented at the 63rd SPE Annual Technical Conference and Exhibition, Houston, TX.
18.
Tabeling, P., Pouliquen, O., Theron, B., and Catala, G., 1991, “Oil Water Flows in Deviated Pipes: Experimental Study and Modeling,” Proceedings, 5th International Conference on Multiphase Flow Production, Cannes, France, pp. 294–306.
19.
Vigneaux
P.
,
Chenais
P.
, and
Hulin
J. P.
,
1988
a, “
Liquid-Liquid Flows in an Inclined Pipe
,”
AIChE Journal
, Vol.
34
, No.
5
, pp.
781
789
.
20.
Vigneaux, P. G., Catala, G. N., and Hulin, J. P., 1988b, “Oil/Water Flow Structure Measurements in Inclined Pipes,” Paper SPE 18217, presented at the 63rd. SPE Annual Technical Conference and Exhibition, Houston, TX.
21.
Zuber, N., and Findlay, J. A., 1965, “Average Volumetric Concentration in Two-Phase Flow Systems,” ASME Journal of Heat Transfer, pp. 453–468.
22.
Zuber, N., and Hench, J., 1962, “Steady State and Transient Void Fraction of Bubbling Systems and Their Operating Limits, Part 1: Steady State Operation,” General Electric Report No. 62GL100.
This content is only available via PDF.
You do not currently have access to this content.