The aim of this work is to demonstrate the capability of an original “modular” simulator tool for the thermoeconomic analysis of thermal-energy systems. The approach employed is based on the Thermoeconomic Functional Analysis (T.F.A.), which, through definition of the “functional productive diagram” and the establishment of the capital cost function of each component, allows the marginal costs and the unit product costs, i.e., the “internal economy,” of the functional exergy flows to be obtained in correspondence to the optimum point. The optimum design of the system is obtained utilizing a traditional optimization technique, which includes both physical structure of the energy system described in terms of thermodynamic variables and cost model (capital cost of the components, maintenance and amortization factors, unit fuel cost, unit electricity cost, etc.). As an application example to show the practicability of the tool, the thermoeconomic analysis of various complex multipressure combined cycles (with or without steam reheating) is carried out. The results are analyzed and discussed in depth.

Issue Section:
Gas Turbines: Cycle Innovations
Topics:
Optimization, Steam, Thermoeconomics, Combined cycles, Design, Economics , Exergy, Flow (Dynamics), Fuels, Functional analysis, Maintenance, Thermal energy
1.
Agazzani, A., Massardo, A., Satta, A., 1995, “Thermoeconomic Analysis of Complex Steam Plants,” ASME Paper No. 95-CTP-38.
2.
Agazzani, A., 1997, “Thermoeconomic Analysis of Energy Systems,” Ph D. Thesis, University of Pisa, Italy.
3.
Bianchi, S., 1995, “Ottimizzazione Tecnico-Economica degli Impianti a Ciclo Combinato ‘Gas-Vapore’ per le Centrali di Zaharani e Beddawi,” Master’s Thesis, University of Genoa, Italy.
4.
Boehm, R. F., 1987, Design Analysis of Thermal Systems, Wiley, New York.
5.
El-Sayed
Y. M.
, and
Evans
R. B.
,
1970
, “
Thermoeconomics and the Design of Heat System
,”
ASME JOURNAL OF ENGINEERING FOR POWER
, Vol.
92
, pp.
27
–
34
.
6.
El-Sayed, Y., and Tribus, M., 1983, “Strategic Use of Thermoeconomics for System Improvement,” in Efficiency and Costing: Second Law Analysis of Processes, R. A. Gaggioli, ed., A.C.S. Symposium Series, No. 235, Washington, DC, pp. 215–239.
7.
Frangopoulos, C. A., 1983, “Thermoeconomic Functional Analysis: a Method for Optimal Design or Improvement of Complex Thermal System,” Ph.D. Thesis, Georgia Institute of Technology, Atlanta, GA.
8.
Frangopoulos, C. A., 1991, “Comparison of Thermoeconomic and Thermodynamic Optimal Designs of a Combined-Cycle Plant,” Proc. of ATHENS ’91, Athens, June 3–6, pp. 305–318.
9.
Frangopoulos
C. A.
,
1992
, “
Optimal Synthesis and Operation of Thermal Systems by the Thermoeconomic Functional Approach
,”
ASME JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER
, Vol.
114
, pp.
707
–
714
.
10.
Lazzaretto, A., and Macor, A., 1994, “Marginal and Average Costs in Engineering Functional Analysis,” presented at the Florence World Energy Research Symposium, FLOWERS ’94, Florence, July 6–8.
11.
Lenti, F., Massardo, A., and Satta, A., 1989, “Thermoeconomic Optimization of a Simple Thermal Power Plant Using Mathematical Minimization Algorithm,” IECEC Paper No. 899341.
12.
Massardo
A.
,
Satta
A.
, and
Marini
M.
,
1990
, “
Axial Flow Compressor Design Optimization
,”
ASME Journal of Turbomachinery
, Vol.
112
, pp.
399
–
410
.
13.
Serra, L., Lozano, A., Valero, A., and Torres, C., 1995, “On Average and Marginal Costs in Thermoeconomics,” Efficiency, Costs, Optimization, Simulation and Environmental Impact of Energy Systems, ECOS ’95, Istanbul, July 11–15.
14.
Tsatsaronis
G.
,
Winhold
M.
,
1985
, “
Exergoeconomic Analysis and Evaluation of Energy Conversion Plants. I—A New General Methodology
,”
Energy
, Vol.
10
, No.
1
, pp.
69
–
80
.
15.
von Spakovsky
M. R.
, and
Evans
R. B.
,
1990
, “
The Design and Performance Optimization of Thermal Systems
,”
ASME JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER
, Vol.
112
, pp.
86
–
93
.
16.
von Spakovsky
M. R.
, and
Evans
R. B.
,
1993
, “
Engineering Functional Analysis—Part I and Part II
,”
ASME Journal of Energy Resources Technology
, Vol.
115
, pp.
86
–
99
.
17.
Valero, A., Lozano, M. A., and Munoz, M., 1986, “A General Theory of Exergy Savings,” “Part I: On Exergetic Cost,” “Part II: On the Thermoeconomic Cost,” “Part III: Energy Savings and Thermoeconomics,” ASME Book H0341A, WAM, AES, Vol. 2–3, pp. 1–21.
18.
Gas Turbine World, 1995, “Gas Turbine World 1995 Handbook,” Pequot Publishing Inc., Fairfield (USA), Vol. 16.
This content is only available via PDF.
Copyright © 1997
 by The American Society of Mechanical Engineers
You do not currently have access to this content.