This paper summarizes and extends recent theoretical, computational, and experimental research into the fluid mechanics, thermodynamics, and heat transfer characteristics of the so-called cover-plate pre-swirl system. Experiments were carried out in a purpose-built rotating-disc rig, and the Reynolds-averaged Navier-Stokes equations were solved using two-dimensional (axisymmetric) and three-dimensional computational codes, both of which incorporated low-Reynolds-number k-ε turbulence models. The free-vortex flow, which occurs inside the rotating cavity between the disc and cover-plate, is controlled principally by the pre-swirl ratio, this is the ratio of the tangential velocity of the air leaving the nozzles to that of the rotating disc. Computed values of the tangential velocity are in good agreement with measurements, and computed distributions of pressure are in close agreement with those predicted by a one-dimensional theoretical model. It is shown theoretically and computationally that there is a critical pre-swirl ratio, for which the frictional moment on the rotating discs is zero, and there is an optimal pre-swirl ratio, where the average Nusselt number is a minimum. Computations show that, for the temperature of the blade-cooling air decreases as increases; for whether the temperature of the cooling air increases or decreases as increases depends on the flow conditions and on the temperature difference between the disc and the air. Owing to the three-dimensional flow and heat transfer near the blade-cooling holes, and to unquantifiable uncertainties in the experimental measurements, there were significant differences between the computed and measured temperatures of the blade-cooling air. In the main, the three-dimensional computations produced smaller differences than the two-dimensional computations. [S0742-4795(00)01902-5]
Skip Nav Destination
Article navigation
July 2000
Technical Papers
Performance of Pre-Swirl Rotating-Disc Systems
Hasan Karabay,
Hasan Karabay
Department of Mechanical Engineering, Faculty of Engineering and Design, University of Bath, Bath BA2 7AY, UK
Search for other works by this author on:
Robert Pilbrow,
Robert Pilbrow
Department of Mechanical Engineering, Faculty of Engineering and Design, University of Bath, Bath BA2 7AY, UK
11
Search for other works by this author on:
Michael Wilson,
Michael Wilson
Department of Mechanical Engineering, Faculty of Engineering and Design, University of Bath, Bath BA2 7AY, UK
Search for other works by this author on:
J. Michael Owen
J. Michael Owen
Department of Mechanical Engineering, Faculty of Engineering and Design, University of Bath, Bath BA2 7AY, UK
Search for other works by this author on:
Hasan Karabay
Department of Mechanical Engineering, Faculty of Engineering and Design, University of Bath, Bath BA2 7AY, UK
Robert Pilbrow
11
Department of Mechanical Engineering, Faculty of Engineering and Design, University of Bath, Bath BA2 7AY, UK
Michael Wilson
Department of Mechanical Engineering, Faculty of Engineering and Design, University of Bath, Bath BA2 7AY, UK
J. Michael Owen
Department of Mechanical Engineering, Faculty of Engineering and Design, University of Bath, Bath BA2 7AY, UK
Contributed by the International Gas Turbine Institute (IGTI) of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS for publication in the ASME JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER. Paper presented at the International Gas Turbine and Aeroengine Congress and Exhibition, Indianapolis, IN, June 7–10, 1999; ASME Paper 99-GT-197. Manuscript received by IGTI March 9, 1999; final revision received by the ASME Headquarters January 3, 2000. Associate Technical Editor: D. Wisler.
J. Eng. Gas Turbines Power. Jul 2000, 122(3): 442-450 (9 pages)
Published Online: January 3, 2000
Article history
Received:
March 9, 1999
Revised:
January 3, 2000
Citation
Karabay , H., Pilbrow, R., Wilson , M., and Owen, J. M. (January 3, 2000). "Performance of Pre-Swirl Rotating-Disc Systems ." ASME. J. Eng. Gas Turbines Power. July 2000; 122(3): 442–450. https://doi.org/10.1115/1.1285838
Download citation file:
Get Email Alerts
Image-based flashback detection in a hydrogen-fired gas turbine using a convolutional autoencoder
J. Eng. Gas Turbines Power
Fuel Thermal Management and Injector Part Design for LPBF Manufacturing
J. Eng. Gas Turbines Power
An investigation of a multi-injector, premix/micromix burner burning pure methane to pure hydrogen
J. Eng. Gas Turbines Power
Related Articles
Heat Transfer in a “Cover-Plate” Preswirl Rotating-Disk System
J. Turbomach (April,1999)
Influence of Fluid Dynamics on Heat Transfer in a Preswirl Rotating-Disk System
J. Eng. Gas Turbines Power (October,2005)
Effect of Radial Location of Nozzles on Heat Transfer in Preswirl Cooling Systems
J. Turbomach (April,2011)
Buoyancy-Induced Flow in Open Rotating Cavities
J. Eng. Gas Turbines Power (October,2007)
Related Proceedings Papers
Related Chapters
Introduction I: Role of Engineering Science
Fundamentals of heat Engines: Reciprocating and Gas Turbine Internal Combustion Engines
Adding Surface While Minimizing Downtime
Heat Exchanger Engineering Techniques
Control and Operational Performance
Closed-Cycle Gas Turbines: Operating Experience and Future Potential