New computational procedures are proposed for evaluating the exhaust brake specific mass emissions of each pollutant species in internal combustion (IC) engines. The procedures start from the chemical reaction of fuel with combustion air and, based on the measured exhaust raw emissions THC, CO, calculate the volume fractions of the compounds in the exhaust gases, including those that are not usually measured, such as water, nitrogen and hydrogen. The molecular mass of the exhaust gases is then evaluated and the brake specific emissions can be obtained if the exhaust flow rate and the engine power output are measured. The algorithm can also be applied to the evaluation of air-fuel ratio from measured raw volume emissions of IC engines. The new procedures take the effects of various fuel and combustion air compositions into account, with particular reference to different natural gas blends as well as to the presence of water vapor, Ar and He in the combustion air. In the paper, the algorithms are applied to the evaluation of air-fuel ratio and brake specific mass emissions in an automotive bi-fuel Spark Ignition (SI) engine with multipoint sequential port-fuel injection. The experimental tests were carried out in a wide range of steady-state operating conditions under both gasoline and compressed natural gas operations. The specific emissions calculated from the new procedures are compared to those evaluated by applying Society of Automotive Engineers (SAE) and International Standards Organization (ISO) recommended practices and the air-fuel ratio results are compared to those obtained either from directly measured air and fuel mass flow rates or from Universal Exhaust Gas Oxygen (UEGO) sensor data. The sensitivity of the procedure results to the main engine working parameters, the influence of environmental conditions (in particular the effect of air humidity on formation) and the experimental uncertainties are also determined.
Skip Nav Destination
e-mail: ezio.spessa@polito.it
Article navigation
October 2005
Technical Papers
Methods for Specific Emission Evaluation in Spark Ignition Engines Based on Calculation Procedures of Air-Fuel Ratio: Development, Assessment, and Critical Comparison
Stefano d’Ambrosio,
Stefano d’Ambrosio
Dipartimento di Energetica IC Engines Advanced Laboratory, Politecnico di Torino, Corso Duca degli Abruzzi, 24, Torino 10129, Italy
Search for other works by this author on:
Ezio Spessa,
e-mail: ezio.spessa@polito.it
Ezio Spessa
Dipartimento di Energetica IC Engines Advanced Laboratory, Politecnico di Torino, Corso Duca degli Abruzzi, 24, Torino 10129, Italy
Search for other works by this author on:
Alberto Vassallo
Alberto Vassallo
Dipartimento di Energetica IC Engines Advanced Laboratory, Politecnico di Torino, Corso Duca degli Abruzzi, 24, Torino 10129, Italy
Search for other works by this author on:
Stefano d’Ambrosio
Dipartimento di Energetica IC Engines Advanced Laboratory, Politecnico di Torino, Corso Duca degli Abruzzi, 24, Torino 10129, Italy
Ezio Spessa
Dipartimento di Energetica IC Engines Advanced Laboratory, Politecnico di Torino, Corso Duca degli Abruzzi, 24, Torino 10129, Italy
e-mail: ezio.spessa@polito.it
Alberto Vassallo
Dipartimento di Energetica IC Engines Advanced Laboratory, Politecnico di Torino, Corso Duca degli Abruzzi, 24, Torino 10129, Italy
Contributed by the Internal Combustion Engine Division of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS for publication in the ASME JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER. Manuscript received by the ICE Division, October 24, 2003; final revision received June 1, 2004. Associate Editor: D. Assanis.
J. Eng. Gas Turbines Power. Oct 2005, 127(4): 869-882 (14 pages)
Published Online: September 20, 2005
Article history
Received:
October 24, 2003
Revised:
June 1, 2004
Online:
September 20, 2005
Citation
d’Ambrosio , S., Spessa, E., and Vassallo, A. (September 20, 2005). "Methods for Specific Emission Evaluation in Spark Ignition Engines Based on Calculation Procedures of Air-Fuel Ratio: Development, Assessment, and Critical Comparison ." ASME. J. Eng. Gas Turbines Power. October 2005; 127(4): 869–882. https://doi.org/10.1115/1.1852566
Download citation file:
Get Email Alerts
Image-based flashback detection in a hydrogen-fired gas turbine using a convolutional autoencoder
J. Eng. Gas Turbines Power
Fuel Thermal Management and Injector Part Design for LPBF Manufacturing
J. Eng. Gas Turbines Power
An investigation of a multi-injector, premix/micromix burner burning pure methane to pure hydrogen
J. Eng. Gas Turbines Power
Related Articles
Carbon Capture for Automobiles Using Internal Combustion Rankine Cycle Engines
J. Eng. Gas Turbines Power (May,2009)
Current Regulations Impacting Exhaust Emissions From Stationary Internal Combustion Engines
J. Eng. Gas Turbines Power (July,1989)
A Study of Combustion Inefficiency in Diesel Low Temperature Combustion and Gasoline–Diesel RCCI Via Detailed Emission Measurement
J. Eng. Gas Turbines Power (December,2015)
A Two-Time-Scale Infinite-Adsorption Model of Three Way Catalytic Converters During the Warm-Up Phase
J. Dyn. Sys., Meas., Control (March,2001)
Related Proceedings Papers
Related Chapters
Reference Method Accuracy and Precision (ReMAP): Phase I
Reference Method Accuracy and Precision (ReMAP): Phase 1 (CRTD Vol. 60)
Introduction
Consensus on Operating Practices for Control of Water and Steam Chemistry in Combined Cycle and Cogeneration
Thermodynamic Performance
Closed-Cycle Gas Turbines: Operating Experience and Future Potential