One potential method for controlling the combustion phasing of a homogeneous charge compression ignition (HCCI) engine is to vary the fuel chemistry using two fuels with different auto-ignition characteristics. Although a dual-fuel engine concept is technically feasible with current engine management and fuel delivery system technologies, this is not generally seen as a practical solution due to the necessity of supplying and storing two fuels. Onboard partial reforming of a hydrocarbon fuel is seen to be a more attractive way of realizing a dual-fuel concept, while relying on only one fuel supply infrastructure. Reformer gas (RG) is a mixture of light gases dominated by hydrogen and carbon monoxide that can be produced from any hydrocarbon fuel using an onboard fuel processor. RG has a high resistance to auto-ignition and wide flammability limits. The ratio of H2 to CO produced depends on the reforming method and conditions, as well as the hydrocarbon fuel. In this study, a cooperative fuel research engine was operated in HCCI mode at elevated intake air temperatures and pressures. n-heptane was used as the hydrocarbon blending component because of its high cetane number and well-known fuel chemistry. RG was used as the low cetane blending component to retard the combustion phasing. Other influential parameters, such as air/fuel ratio, EGR, and intake temperature, were maintained constant. The experimental results show that increasing the RG fraction retards the combustion phasing to a more optimized value causing indicated power and fuel conversion efficiency to increase. RG reduced the first stage of heat release, extended the negative temperature coefficient delay period, and retarded the main stage of combustion. Two extreme cases of RG composition with H2/CO ratios of 3/1 and 1/1 were investigated. The results show that both RG compositions retard the combustion phasing, but that the higher hydrogen fraction RG is more effective. A single-zone model with detailed chemical kinetics was used to interpret the experimental results. The effect of RG on combustion phasing retardation was confirmed. It was found that the low temperature heat release was inhibited by a reduction in intermediate radical mole fractions during low temperature reactions and during the early stages of the negative temperature coefficient delay period.

1.
Upatniek
,
A.
,
Mueller
,
C. J.
, and
Martin
,
G. C.
, 2005, “
The Influence of Charge-Gas Dilution and Temperature on DI Diesel Combustion Processes Using a Short-Ignition-Delay, Oxygenated Fuel
,” SAE Paper No. 2005-01-2088.
2.
Sjöberg
,
M.
, and
Dec
,
J. E.
, 2003, “
Combined Effects of Fuel-Type and Engine Speed on Intake Temperature Requirements and Completeness of Bulk-Gas Reactions for HCCI Combustion
,” SAE Paper No. 2003-01-3173.
3.
Christensen
,
M.
,
Hultqvist
,
A.
, and
Johansson
,
B.
, 1999, “
Demonstrating the Multi-Fuel Capability of a Homogeneous Charge Compression Ignition Engine With Variable Compression Ratio
,” SAE Paper, 1999-01-3679.
4.
Stanglmaier
,
R. H.
,
Ryan
,
T. W.
, and
Souder
,
J. S.
, 2001, “
HCCI Operation of a Dual-Fuel Natural Gas Engine for Improved Fuel Efficiency and Ultra-Low NOx Emissions at Low-to-Moderate Engine Loads
,” SAE Paper No. 2001-01-1897.
5.
Zheng
,
Z.
,
Yao
,
M.
,
Chen
,
Z.
, and
Zhang
,
B.
, 2004, “
Experimental Study on HCCI Combustion of Dimethyl Ether (DME)/Methanol Dual Fuel
,” SAE Paper No. 2004-01-2993.
6.
Jamal
,
Y.
, and
Wyszynski
,
M. L.
, 1994, “
On-Board Generation of Hydrogen-Rich Gaseous Fuels—A Review
,”
Int. J. Hydrogen Energy
0360-3199,
19
(
7
), pp.
557
572
.
7.
Dicks
,
A. L.
, 1996, “
Hydrogen Generation From Natural Gas for the Fuel Cell Systems of Tomorrow
,”
J. Power Sources
0378-7753,
61
, pp.
113
124
.
8.
Shudo
,
T.
, 2006, “
An HCCI Combustion Engine System Using On-Board Reformed Gases of Methanol With Waste Heat Recovery: Ignition Control by Hydrogen
,”
Int. J. Veh. Des.
0143-3369,
41
, pp.
206
225
.
9.
Tsolakis
,
A.
, and
Megaritis
,
A.
, 2005, “
Partially Premixed Charge Compression Ignition Engine With On-Board H2 Production by Exhaust Gas Fuel Reforming of Diesel and Biodiesel
,”
Int. J. Hydrogen Energy
,
30
, pp.
731
745
. 0360-3199
10.
Eng
,
J. A.
,
Leppard
,
W. R.
, and
Sloane
,
T. M.
, 2002, “
The Effect of POx on the Autoignition Chemistry of n-Heptane and Iso-Octane in an HCCI Engine
,” SAE Paper No. 2002-01-2861.
11.
Hosseini
,
V.
, and
Checkel
,
M. D.
, 2006, “
Using Reformer Gas to Enhance HCCI Combustion of CNG in a CFR Engine
,” SAE Paper No. 2006-01-3247.
12.
Hosseini
,
V.
, and
Checkel
,
M. D.
, 2007, “
Effect of Reformer Gas on HCCI Combustion—Part I: High Octane Fuels
,” SAE Paper No. 2007-01-0208.
13.
Hosseini
,
V.
, and
Checkel
,
M. D.
, 2007, “
Effect of Reformer Gas on HCCI Combustion—Part II: Low Octane Fuels
,” SAE Paper No. 2007-01-0206.
14.
Hosseini
,
V.
, and
Checkel
,
M. D.
, 2005, “
Alternative Mode Combustion Study: HCCI Fueled With Heptane and Spark Ignition Fueled With Reformer Gas
,”
ASME Internal Combustion Engine Fall Technical Conference
, Ottawa, Canada, Paper No. ICEF2005-1240.
15.
Mueller
,
C. J.
, 2005, “
The Quantification of Mixture Stoichiometry When Fuel Molecules Contain Oxidizer Elements or Oxidizer Molecules Contain Fuel Elements
,” SAE Paper No. 2005-01-3705.
16.
Heywood
,
J. B.
, 1988,
Internal Combustion Engine Fundamentals
,
McGraw-Hill
,
New York
.
17.
Chang
,
J.
,
Güralp
,
O.
,
Filipi
,
Z.
,
Assanis
,
D.
,
Kuo
,
T. -W.
,
Najt
,
P.
, and
Rask
,
R.
, 2004, “
New Heat Transfer Correlation for an HCCI Engine Derived From Measurements of Instantaneous Surface Heat Flux
,” SAE Paper No. 2004-01-2996.
18.
Hosseini
,
V.
, and
Checkel
,
M. D.
, 2008, “
Reformer Gas Composition Effect on HCCI Combustion of N-Heptane, Iso-Octane, and Natural Gas
,” SAE Paper No. 2008-01-0049.
19.
Hosseini
,
V.
, 2008, “
Reformer Gas Application in HCCI Combustion Engine
,” Ph.D. thesis, University of Alberta, Edmonton, AB, Canada.
20.
Kongsereeparp
,
P.
,
Kashani
,
B.
, and
Checkel
,
M. D.
, 2005, “
A Stand-Alone Multi-Zone Model for Combustion in HCCI Engines
,”
ASME Internal Combustion Engine Fall Technical Conference
, Ottawa, Canada, Paper No. ICEF2005-1241.
21.
Kongsereeparp
,
P.
, and
Checkel
,
M. D.
, 2007, “
Investigating the Effects of Reformed Fuel Blending in a Natural Gas- and N-Heptane-HCCI Engine Using a Multi-Zone Model
,” SAE Paper No. 2007-01-0205.
22.
Kongsereeparp
,
P.
, and
Checkel
,
M. D.
, 2007, “
Novel Method of Setting Initial Conditions for Multi-Zone HCCI Combustion Modeling
,” SAE Paper No. 2007-01-0674.
23.
Kongsereeparp
,
P.
, and
Checkel
,
M. D.
, 2007, “
Investigating the Effects of Reformed Fuel Blending in a Methane- or N-Heptane-HCCI Engine Using a Multi-Zone Model
,” SAE Paper No. 2007-01-0205.
25.
Hosseini
,
V.
,
Neill
,
W. S.
, and
Checkel
,
M. D.
, 2008, “
Controlling N-Heptane HCCI Combustion With Partial Reforming: Experimental Results and Modeling Analysis
,”
ASME Internal Combustion Engine Spring Technical Conference
, Chicago, IL, Paper No. ICEF200-1618.
26.
Subramanian
,
G.
,
Da Cruz
,
A. P.
,
Bounaceur
,
R.
, and
Vervisch
,
L.
, 2007, “
Chemical Impact of CO and H2 Addition on the Auto-Ignition Delay of Homogenous N-Heptane/Air Mixtures
,”
Combust. Sci. Technol.
0010-2202,
179
(
9
), pp.
1937
1962
.
27.
Shudo
,
T.
, and
Yamada
,
H.
, 2007, “
Hydrogen as an Ignition-Controlling Agent for HCCI Combustion Engine by Suppressing the Low-Temperature Oxidation
,”
Int. J. Hydrogen Energy
0360-3199,
32
(
14
), pp.
3066
3072
.
28.
Peng
,
Z.
,
Zhao
,
H.
, and
Ladommatos
,
N.
, 2003, “
Effects of Air/Fuel Ratios and EGR Rates on HCCI Combustion of N-Heptane, a Diesel Type Fuel
,” SAE Paper No. 2003-01-0747.
29.
Docter
,
A.
, and
Lamm
,
A.
, 1999, “
Gasoline Fuel Cell Systems
,”
J. Power Sources
0378-7753,
84
, pp.
194
200
.
30.
Dean
,
J. A.
, 1999,
Lange’s Handbook of Chemistry
, 15th ed.,
McGraw-Hill
,
New York
.
31.
Shudo
,
T.
, and
Takahashi
,
T.
, 2004, “
Influence of Reformed Gas Composition on HCCI Combustion of Onboard Methanol-Reformed Gases
,” SAE Paper No. 2004-01-1908.
You do not currently have access to this content.