Intake tuning is a widely recognized method for optimizing the performance of a naturally aspirated engine for motorsports applications. Wave resonance and Helmholtz theories are useful for predicting the impact of intake runner length on engine performance. However, there is very little information in the literature regarding the effects of intake plenum volume. The goal of this study was to determine the effects of intake plenum volume on steady state and transient engine performance for a restricted naturally aspirated engine for Formula Society of Automotive Engineers (FSAE) vehicle use. Testing was conducted on a four cylinder 600 cc motorcycle engine fitted with a 20 mm restrictor in compliance with FSAE competition rules. Plenum sizes were varied from 2 to 10 times engine displacement (1.2–6.0 l) and engine speeds were varied from 3000 rpm to 12,500 rpm. Performance metrics including volumetric efficiency, torque, and power were recorded at steady state conditions. Experimental results showed that engine performance increased modestly as plenum volume was increased from 2 to 8 times engine displacement (4.8 l). Increasing plenum volume beyond 4.8 l resulted in significant improvement in performance parameters. Overall, peak power was shown to increase from 54 kW to 63 kW over the range of plenums tested. Additionally, transient engine performance was evaluated using extremely fast (60 ms) throttle opening times for the full range of plenum sizes tested. In-cylinder pressure was used to calculate cycle-resolved gross indicated mean effective pressure (IMEPg) development during these transients. Interestingly, the cases with the largest plenum sizes only took 1 to 2 extra cycles (30–60 ms) to achieve maximum IMEPg levels when compared with the smaller volumes. In fact, the differences were so minor that it would be doubtful that a driver would notice the lag. Additional metrics included time for the plenums to fill and an analysis of manifold absolute pressure and peak in-cylinder pressure development during and after the throttle transient. Plenums below 4.8 l completely filled even before the transient was completed.
Skip Nav Destination
Article navigation
January 2011
Research Papers
The Effects of Intake Plenum Volume on the Performance of a Small Naturally Aspirated Restricted Engine
Leonard J. Hamilton,
Leonard J. Hamilton
U.S. Naval Academy
, Annapolis, MD 21402
Search for other works by this author on:
Jim S. Cowart,
Jim S. Cowart
U.S. Naval Academy
, Annapolis, MD 21402
Search for other works by this author on:
Jasen E. Lee,
Jasen E. Lee
U.S. Naval Academy
, Annapolis, MD 21402
Search for other works by this author on:
Ryan E. Amorosso
Ryan E. Amorosso
U.S. Naval Academy
, Annapolis, MD 21402
Search for other works by this author on:
Leonard J. Hamilton
U.S. Naval Academy
, Annapolis, MD 21402
Jim S. Cowart
U.S. Naval Academy
, Annapolis, MD 21402
Jasen E. Lee
U.S. Naval Academy
, Annapolis, MD 21402
Ryan E. Amorosso
U.S. Naval Academy
, Annapolis, MD 21402J. Eng. Gas Turbines Power. Jan 2011, 133(1): 012801 (7 pages)
Published Online: September 24, 2010
Article history
Received:
September 23, 2009
Revised:
September 25, 2009
Online:
September 24, 2010
Published:
September 24, 2010
Citation
Hamilton, L. J., Cowart, J. S., Lee, J. E., and Amorosso, R. E. (September 24, 2010). "The Effects of Intake Plenum Volume on the Performance of a Small Naturally Aspirated Restricted Engine." ASME. J. Eng. Gas Turbines Power. January 2011; 133(1): 012801. https://doi.org/10.1115/1.4001071
Download citation file:
Get Email Alerts
Cited By
Heat Release Characteristics of a Volatile, Oxygenated, and Reactive Fuel in a Direct Injection Engine
J. Eng. Gas Turbines Power
Comprehensive Life Cycle Analysis of Diverse Hydrogen Production Routes and Application on a Hydrogen Engine
J. Eng. Gas Turbines Power
Related Articles
On the Effect of Transient In-Plane Dynamics of the Compression Ring Upon Its Tribological Performance
J. Eng. Gas Turbines Power (March,2015)
On the Transient Three-Dimensional Tribodynamics of Internal Combustion Engine Top Compression Ring
J. Eng. Gas Turbines Power (June,2017)
Statistical Correlation Between the Crankshaft’s Speed Variation and Engine Performance—Part II: Detection of Deficient Cylinders and Mean Indicated Pressure Calculation
J. Eng. Gas Turbines Power (July,2003)
Statistical Correlation Between the Crankshaft’s Speed Variation and Engine Performance—Part I: Theoretical Model
J. Eng. Gas Turbines Power (July,2003)
Related Proceedings Papers
Related Chapters
Physiology of Human Power Generation
Design of Human Powered Vehicles
Review of Basic Principles
Fundamentals of heat Engines: Reciprocating and Gas Turbine Internal Combustion Engines
Reciprocating Engine Performance Characteristics
Fundamentals of heat Engines: Reciprocating and Gas Turbine Internal Combustion Engines