This paper presents the first experimental engine and test rig results obtained from a fast response cooled total pressure probe. The first objective of the probe design was to favor continuous immersion of the probe into the engine to obtain a time series of pressure with a high bandwidth and, therefore, statistically representative average fluctuations at the blade passing frequency. The probe is water cooled by a high pressure cooling system and uses a conventional piezoresistive pressure sensor, which yields, therefore, both time-averaged and time-resolved pressures. The initial design target was to gain the capability of performing measurements at the temperature conditions typically found at high pressure turbine exit (8001100°C) with a bandwidth of at least 40 kHz and in the long term at combustor exit (2000 K or higher). The probe was first traversed at the turbine exit of a Rolls-Royce Viper turbojet engine at exhaust temperatures around 750°C and absolute pressure of 2.1 bars. The probe was able to resolve the high blade passing frequency (≈23 kHz) and several harmonics of up to 100 kHz. Besides the average total pressure distributions rom the radial traverses, phase-locked averages and random unsteadiness are presented. The probe was also used in a virtual three-hole mode yielding unsteady yaw angle, static pressure, and Mach number. The same probe was used for measurements in a Rolls-Royce intermediate pressure burner rig. Traverses were performed inside the flame tube of a kerosene burner at temperatures above 1600°C. The probe successfully measured the total pressure distribution in the flame tube and typical frequencies of combustion instabilities were identified during rumble conditions. The cooling performance of the probe is compared with estimations at the design stage and found to be in good agreement. The frequency response of the probe is compared with cold shock-tube results and a significant increase in the natural frequency of the line-cavity system formed by the conduction cooled screen in front of the miniature pressure sensor were observed.

1.
2.
PIWG
, Sensor Specifications, http://www.piwg.orghttp://www.piwg.org
3.
Roberts
,
J.
, 2004, “
Requirements for Instrumentation Technology for Gas Turbine Propulsion Systems
,”
Advanced Measurement Techniques for Aero Engines and Stationary Gas Turbines
,
VKI LS
,
Rhode-Saint-Genese, Belgium
.
4.
Niska
,
H.
, 2009, “
Requirements for Advanced High Temperature Instrumentation and Measurements in Gas Turbine Engines
,”
Advanced High Temperature Instrumentation for Gas Turbine Applications
,
VKI LS
,
Rhode-Saint-Genese, Belgium
.
5.
Simon
,
D. L.
,
Garg
,
S.
,
Hunter
,
G. W.
,
Guo
,
T. -H.
, and
Semega
,
K. J.
, 2004, “
Sensor Needs for Control and Health Management of Intelligent Aircraft Engines
,”
ASME
Paper No. GT2004-54324.
6.
Kupferschmied
,
P.
,
Koppel
,
P.
,
Gizzi
,
W.
,
Roduner
,
C.
, and
Gyamarthy
,
G.
, 2000, “
Time-Resolved Flow Measurements With Fast-Response Aerodynamic Probes in Turbomachines
,”
Meas. Sci. Technol.
0957-0233,
11
(
7
), pp.
1036
1054
.
7.
Armentrout
,
E. C.
, and
Kicks
,
J. C.
, 1979, “
Pressure Instrumentation for Gas Turbine Engines—A Review of Measurement Technology
,”
ASME J. Eng. Power
0022-0825,
101
.
8.
Lakshminarayana
,
B.
, 1980, “
Techniques for Aerodynamic and Turbulence Measurements in Turbomachinery Rotors
,”
Measurement Methods in Rotating Components of Turbomachines
,
B.
Lakshminarayana
and
P.
Runstadler
, Jr.
, eds.,
ASME
,
New York
.
9.
Carta
,
F.
, and
O’Brien
,
R.
, 1980, “
Unsteady Aerodynamic Measurement Techniques for Turbomachinery Research
,”
Measurement Methods in Rotating Components of Turbomachines
,
B.
Lakshminarayana
and
P.
Runstadler
, Jr.
, eds.,
ASME
,
New York
.
10.
Sieverding
,
C.
,
Arts
,
T.
,
De’nos
,
R.
, and
Brouckaert
,
J.
, 2000, “
Measurement Techniques for Unsteady Flows in Turbomachines
,”
Experiments in Fluids
,
Springer Verlag
, Vol.
28
.
11.
Ainsworth
,
R. W.
,
Miller
,
R. J.
,
Moss
,
R. W.
, and
Thorpe
,
S.
, 2000, “
Unsteady Pressure Measurement
,”
Meas. Sci. Technol.
0957-0233,
11
, pp.
1055
1076
.
12.
Brouckaert
,
J.
,
Mersinligil
,
M.
,
Desset
,
J.
, and
Pau
,
M.
, 2008, “
Development of a High Temperature Fast Response Cooled Total Pressure Probe
,”
Advanced High Temperature Instrumentation for Gas Turbine Applications
,
VKI LS
,
Rhode-Saint-Genese, Belgium
.
13.
Grey
,
J.
, 1970, “
Probe Measurements in High-Temperature Gases and Dense Plasmas
,”
AGARDograph on Measurement Techniques in Heat Transfer
,
E. R. G.
Eckert
and
R. J.
Goldstein
, eds.,
NATO AGARD
, Vol.
130
, pp.
269
307
.
14.
Nieberding
,
W. C.
, and
Englund
,
D. R.
, Jr.
, 1972, “
Modularized Instrument System for Turbojet Engine Test Facilities
,”
Symposium on Instrumentation for Airbreathing Propulsion, Progress in Astronautics and Aeronautics
,
A.
Fuhs
and
M.
Kingery
, eds.,
MIT
, Vol.
34
, pp.
206
215
.
15.
Moore
,
M. T.
, 1977, “
High Temperature-High Response Fluctuating Pressure Measurements
,”
Proceedings of the 23rd International Instrumentation Symposium
, Las Vegas, NV, May 1–5,
Instrument Society of America
,
Pittsburgh, PA
, pp.
469
473
.
16.
Larguier
,
R.
, 1985, “
Experimental Analysis Methods for Unsteady Flows in Turbomachines
,”
Seventh International Symposium on Air Breathing Engines
, Beijing, People’s Republic of China, Sep. 2–6, pp.
279
289
,
17.
Brouckaert
,
J.
,
Mersinligil
,
M.
, and
Pau
,
M.
, 2009, “
A Conceptual Design Study for a New High Temperature Fast Response Cooled Total Pressure Probe
,”
ASME J. Eng. Gas Turbines Power
0742-4795,
131
(
2
), p.
021602
.
18.
Bergh
,
H.
, and
Tijdeman
,
H.
, 1965, “
Theoretical and Experimental Results for the Dynamic Response of Pressure Measuring Systems
,” Report No. NLR-TR-F.238.
19.
Mersinligil
,
M.
,
Brouckaert
,
J.
, and
Desset
,
J.
, 2010, “
First Unsteady Pressure Measurements With a Fast Response Cooled Total Pressure Probe in High Temperature Gas Turbine Environments
,”
ASME
Paper No. GT2010-23630.
20.
Ivey
,
P. C.
, and
Ferguson
,
D. G.
, 2002, “
An Air Cooled Jacket Designed to Protect Unsteady Pressure Transducers at Elevated Temperatures in Gas Turbine Engines
,”
ASME Turbo Expo 2002
.
21.
Wyler
,
J. S.
, 1975, “
Probe Blockage Effects in Free Jets and Closed Tunnels
,”
ASME J. Eng. Power
0022-0825,
97
(
4
), pp
509
514
.
You do not currently have access to this content.