Abstract

Increasing the natural gas (NG) use in heavy-duty engines is beneficial for reducing greenhouse-gas emissions from power generation and transportation. However, converting compression ignition (CI) engines to NG spark ignition operation can increase methane emissions without expensive aftertreatment, thereby defeating the purpose of utilizing a low carbon fuel. The widely accepted explanation for the low combustion efficiency in such retrofitted engines is the lower laminar flame speed of natural gas. In addition, diesel engine's larger bowl size compared to the traditional gasoline engines increases the flame travel length inside the chamber and extends the combustion duration. Optical measurements in this study suggested a fast-propagating flame developed even at extremely lean operation. A three-dimensional numerical simulation showed that the squish region of the bowl-in-piston chamber generated a high turbulence intensity inside the bowl. However, the flame propagation speed reduced by 55% when transiting from the bowl to the squish region, due to the large decrease in turbulence intensity inside the squish region. Moreover, the squish volume trapped an important fuel fraction, which experienced a slow and inefficient burning process during the expansion stroke. This resulted in increased methane emissions and reduced combustion efficiency. Overall, it was the specifics of the combustion inside a bowl-in-piston chamber not the methane's slow laminar flame speed that contributed to the low methane combustion efficiency for the retrofitted engine. The results suggest that optimizing the chamber shape is paramount to boost engine efficiency and decrease its emissions.

References

1.
Langness
,
C.
,
Mattson
,
J.
, and
Depcik
,
C.
,
2017
, “
Moderate Substitution of Varying Compressed Natural Gas Constituents for Assisted Diesel Combustion
,”
Combust. Sci. Technol.
,
189
(
8
), pp.
1354
1372
.10.1080/00102202.2017.1295040
2.
Wang
,
J.
,
Duan
,
X.
,
Wang
,
W.
,
Guan
,
J.
,
Li
,
Y.
, and
Liu
,
J.
,
2021
, “
Effects of the Continuous Variable Valve Lift System and Miller Cycle Strategy on the Performance Behavior of the Lean-Burn Natural Gas Spark Ignition Engine
,”
Fuel
,
297
, p.
120762
.10.1016/j.fuel.2021.120762
3.
Donateo
,
T.
,
Tornese
,
F.
, and
Laforgia
,
D.
,
2013
, “
Computer-Aided Conversion of an Engine From Diesel to Methane
,”
Appl. Energy
,
108
, pp.
8
23
.10.1016/j.apenergy.2013.03.002
4.
Gupta
,
M.
,
Bell
,
S. R.
, and
Tillman
,
S. T.
,
1996
, “
An Investigation of Lean Combustion in a Natural Gas-Fueled Spark-Ignited Engine
,”
ASME J. Energy Resour. Technol.
,
118
(
2
), pp.
145
151
.10.1115/1.2792706
5.
Langness
,
C.
, and
Depcik
,
C.
,
2016
, “
Statistical Analyses of CNG Constituents on Dual-Fuel Compression Ignition Combustion
,”
SAE
Paper No. 2016-01-0802.10.4271/2016-01-0802
6.
Duan
,
X.
,
Deng
,
B.
,
Liu
,
Y.
,
Li
,
Y.
, and
Liu
,
J.
,
2021
, “
Experimental Study the Impacts of the Key Operating and Design Parameters on the Cycle-to-Cycle Variations of the Natural Gas SI Engine
,”
Fuel
,
290
, p.
119976
.10.1016/j.fuel.2020.119976
7.
Zhao
,
K.
,
Zuo
,
C.
,
Du
,
Q.
,
Jiang
,
Y.
,
Wei
,
K.
,
Wang
,
B.
,
Zhang
,
G.
, and
Dong
,
L.
,
1998
, “
A Study on Combustion System of a Spark Ignition Natural Gas Engine
,”
Trans. CSICE
, 16(1), pp.
1
8
.https://koreascience.kr/article/JAKO200626813114965.pdf
8.
Chiu
,
J. P.
,
Wegrzyn
,
J.
, and
Murphy
,
K. E.
,
2004
, “
Low Emissions Class 8 Heavy-Duty on-Highway Natural Gas and Gasoline Engine
,”
SAE
Paper No. 2004-01-2982.10.4271/2004-01-2982
9.
Raine
,
R. R.
,
Stephenson
,
J.
, and
Elder
,
S. T.
,
1988
, “
Characteristics of Diesel Engines Converted to Spark Ignition Operation Fuelled With Natural Gas
,”
SAE
Paper No. 880149.10.4271/880149
10.
Weide
,
J.
,
Seppen
,
J. J.
,
Ling
,
J. A.
, and
Dekker
,
H. J.
,
1988
, “
Experiences with CNG and LPG Operated Heavy Duty Vehicles with Emphasis on U.S. HD Diesel Emission Standards
,”
SAE
Paper No. 881657.10.4271/881657
11.
Zhang
,
Q.
,
Xu
,
Z.
,
Li
,
M.
, and
Shao
,
S.
,
2016
, “
Combustion and Emissions of a Euro VI Heavy-Duty Natural Gas Engine Using EGR and TWC
,”
J. Nat. Gas Sci. Eng.
,
28
, pp.
660
671
.10.1016/j.jngse.2015.12.015
12.
Weaver
,
C. S.
,
1989
, “
Natural Gas Vehicles-a Review of the State of the Art
,”
SAE Trans.
,
98
, pp.
1190
1210
.10.4271/892133
13.
Duan
,
X.
,
Zhang
,
S.
,
Liu
,
Y.
,
Li
,
Y.
,
Liu
,
J.
,
Lai
,
M. C.
, and
Deng
,
B.
,
2020
, “
Numerical Investigation the Effects of the Twin-Spark Plugs Coupled With EGR on the Combustion Process and Emissions Characteristics in a Lean Burn Natural Gas SI Engine
,”
Energy
,
206
, p.
118181
.10.1016/j.energy.2020.118181
14.
Wu
,
C.
,
Li
,
T.
, and
Deng
,
K.
,
2018
, “
Knock Impact Factors in a Large Bore SI CNG Engine
,”
Trans. CSICE
,
6
(
1
), pp.
507
511
.
15.
Duan
,
X.
,
Deng
,
B.
,
Liu
,
Y.
,
Zou
,
S.
,
Liu
,
J.
, and
Feng
,
R.
,
2020
, “
An Experimental Study the Impact of the Hydrogen Enrichment on Cycle-to-Cycle Variations of the Large Bore and Lean Burn Natural Gas Spark-Ignition Engine
,”
Fuel
,
282
, p.
118868
.10.1016/j.fuel.2020.118868
16.
Liu
,
J.
,
Ulishney
,
C.
, and
Dumitrescu
,
C. E.
,
2020
, “
Engine Performance and Emissions for a Heavy-Duty Diesel Engine Converted to Stoichiometric Natural Gas Operation
,”
ASME
Paper No. GT2004-53272.10.1115/GT2004-53272
17.
Bhasker
,
J. P.
, and
Porpatham
,
E.
,
2017
, “
Effects of Compression Ratio and Hydrogen Addition on Lean Combustion Characteristics and Emission Formation in a Compressed Natural Gas Fuelled Spark Ignition Engine
,”
Fuel
,
208
, pp.
260
270
.10.1016/j.fuel.2017.07.024
18.
Reyes
,
M.
,
Tinaut
,
F. V.
,
Giménez
,
B.
, and
Pérez
,
A.
,
2015
, “
Characterization of Cycle-to-Cycle Variations in a Natural Gas Spark Ignition Engine
,”
Fuel
,
140
, pp.
752
761
.10.1016/j.fuel.2014.09.121
19.
Meyer
,
R.
,
Meyers
,
D.
,
Shahed
,
S. M.
, and
Duggal
,
V. K.
,
1992
, “
Development of a heavy duty on-highway natural gas-fueled engine
,”
SAE
Paper No. 922362.10.4271/922362
20.
Liu
,
J.
,
Dumitrescu
,
C. E.
,
Bommisetty
,
H.
, and
Ulishney
,
C.
,
1982
, “
Conversion of a Heavy-Duty Diesel Engine to Natural-Gas Spark-Ignition Operation: Test Bench Development
,”
ASME
Paper No. 82-GT-255.10.1115/82-GT-255
21.
Bowditch
,
F. W.
,
1961
, “
A New Tool for Combustion Research a Quartz Piston Engine
,”
SAE
Paper No. 610002.10.4271/610002
22.
Otsu
,
N.
,
1979
, “
A Threshold Selection Method From Gray-Level Histograms
,”
IEEE Trans. Syst., Man, Cybern.
,
9
(
1
), pp.
62
66
.10.1109/TSMC.1979.4310076
23.
Jana, S., Parekh, R., and Sarkar, B.,
2021
, “Chapter 3 - A Semi-Supervised Approach for Automatic Detection and Segmentation of Optic Disc From Retinal Fundus Image,” Handbook of Computational Intelligence in Biomedical Engineering and Healthcare, J. Nayak, B. Naik, D. Pelusi, and A. K. Das, eds., Academic Press, Cambridge, ML, pp. 65–91.
24.
Han
,
Z.
, and
Reitz
,
R. D.
,
1995
, “
Turbulence Modeling of Internal Combustion Engines Using RNG κ-ε Models
,”
Combust. Sci. Technol.
,
106
(
4–6
), pp.
267
295
.10.1080/00102209508907782
25.
Fan
,
L.
,
Li
,
G.
,
Han
,
Z.
, and
Reitz
,
R. D.
,
1999
, “
Modeling Fuel Preparation and Stratified Combustion in a Gasoline Direct Injection Engine
,”
SAE
Paper No. 1999-01-0175.10.4271/1999-01-0175
26.
Tan
,
Z.
, and
Reitz
,
R. D.
,
2006
, “
An Ignition and Combustion Model Based on the Level-Set Method for Spark Ignition Engine Multidimensional Modeling
,”
Combust. Flame
,
145
(
1–2
), pp.
1
15
.10.1016/j.combustflame.2005.12.007
27.
ANSYS, 2016, “ANSYS® Forte User Guide,” Release 17.2., Ansys, Inc., Canonsburg, PA.
28.
Liu
,
J.
,
2018
, “
Investigation of Combustion Characteristics of a Heavy-Duty Diesel Engine Retrofitted to Natural Gas Spark Ignition Operation
,” Ph.D. dissertation,
West Virginia University
,
Morgantown, WV
.
29.
Heywood
,
J. B.
,
1988
,
Internal Combustion Engine Fundamentals
,
McGraw-Hill
,
New York
.
You do not currently have access to this content.