Metal nanoparticle has been a promising option for fillers in thermal interface materials due to its low cost and ease of fabrication. However, nanoparticle aggregation effect is not well understood because of its complexity. Theoretical models, like effective medium approximation model, barely cover aggregation effect. In this work, we have fabricated nickel–epoxy nanocomposites and observed higher thermal conductivity than effective medium theory predicts. Smaller particles are also found to show higher thermal conductivity, contrary to classical models indicate. A two-level effective medium approximation (EMA) model is developed to account for aggregation effect and to explain the size-dependent enhancement of thermal conductivity by introducing local concentration in aggregation structures.
Skip Nav Destination
Article navigation
Research-Article
Effect of Particle Size and Aggregation on Thermal Conductivity of Metal–Polymer Nanocomposite
Wonjun Park,
Wonjun Park
School of Electrical and Computer Engineering;
Search for other works by this author on:
Yong P. Chen,
Yong P. Chen
Department of Physics and Astronomy;
Birck Nanotechnology Center;
School of Electrical and Computer Engineering,
Purdue University,
West Lafayette, IN 47907
e-mail: yongchen@purdue.edu
Purdue University,
West Lafayette, IN 47907
e-mail: yongchen@purdue.edu
Search for other works by this author on:
Xiulin Ruan
Xiulin Ruan
School of Mechanical Engineering;
Search for other works by this author on:
Xiangyu Li
School of Mechanical Engineering;
Wonjun Park
School of Electrical and Computer Engineering;
Yong P. Chen
Department of Physics and Astronomy;
Birck Nanotechnology Center;
School of Electrical and Computer Engineering,
Purdue University,
West Lafayette, IN 47907
e-mail: yongchen@purdue.edu
Purdue University,
West Lafayette, IN 47907
e-mail: yongchen@purdue.edu
Xiulin Ruan
School of Mechanical Engineering;
Contributed by the Heat Transfer Division of ASME for publication in the JOURNAL OF HEAT TRANSFER. Manuscript received February 23, 2016; final manuscript received August 21, 2016; published online October 11, 2016. Assoc. Editor: Alan McGaughey.
J. Heat Transfer. Feb 2017, 139(2): 022401 (5 pages)
Published Online: October 11, 2016
Article history
Received:
February 23, 2016
Revised:
August 21, 2016
Citation
Li, X., Park, W., Chen, Y. P., and Ruan, X. (October 11, 2016). "Effect of Particle Size and Aggregation on Thermal Conductivity of Metal–Polymer Nanocomposite." ASME. J. Heat Transfer. February 2017; 139(2): 022401. https://doi.org/10.1115/1.4034757
Download citation file:
Get Email Alerts
Cited By
Effect of Rib Blockage Ratio and Arrangements on Impingement Heat Transfer in Double-Wall Cooling
J. Heat Mass Transfer (September 2023)
Numerical Simulation of Mixed Convection Cooling of Electronic Component Within a Lid-Driven Cubic Cavity Filled With Nanofluid
J. Heat Mass Transfer (September 2023)
Experimental Analysis of the Influential Factors on Mixed Convection Flow in Horizontal Pipes
J. Heat Mass Transfer (September 2023)
The Effect of Biot Number on a Generalized Heat Conduction Solution
J. Heat Mass Transfer
Related Articles
A Micromechanics-Based Elastoplastic Model for Amorphous Composites With Nanoparticle Interactions
J. Appl. Mech (May,2008)
Thermal Conductivity of Metal-Oxide Nanofluids: Particle Size Dependence and Effect of Laser Irradiation
J. Heat Transfer (March,2007)
Modeling the Thermal Conductivity and Phonon Transport in
Nanoparticle Composites Using Monte Carlo Simulation
J. Heat Transfer (April,2008)
Thermal Property Measurements of Reactive Materials: The Macroscopic Behavior of a Nanocomposite
J. Heat Transfer (November,2012)
Related Chapters
Conclusions
Bacteriophage T4 Tail Fibers as a Basis for Structured Assemblies
Characterization and evaluation
Biocompatible Nanomaterials for Targeted and Controlled Delivery of Biomacromolecules
PVDF/CO 3 O 4 Nanocomposites: Porosity, Crystallinity and Conductivity
International Conference on Advanced Computer Theory and Engineering, 4th (ICACTE 2011)