1-9 of 9
Keywords: coolants
Close
Sort by
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Manuf. Sci. Eng. February 2010, 132(1): 011017.
Published Online: February 3, 2010
... viscosity are observed to increase the evaporation rate. It is concluded that a fluid with low surface tension and low viscosity is an effective coolant of the cutting zone, whereas a fluid with low surface tension and high viscosity is effective for lubrication. A faster evaporating liquid implies...
Journal Articles
Publisher: ASME
Article Type: Technical Briefs
J. Manuf. Sci. Eng. December 2009, 131(6): 064506.
Published Online: December 4, 2009
...-cooled turning. However, the tool consumed in air-cooled turning can be reused in dry turning. Further utilization of tool is possible by reusing the failed tool at reduced feed. These strategies of enhancing the tool life require only compressed air as a coolant, and hence, they are environment-friendly...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Manuf. Sci. Eng. February 2009, 131(1): 011003.
Published Online: December 12, 2008
..., it is usually very difficult to monitor their local surface temperatures without destructively inserting thermal sensors into them. However, the measurement of cooling water temperature at the coolant outlet is relatively unproblematic. This work demonstrates that there is a correlation between these two...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Manuf. Sci. Eng. August 2008, 130(4): 041014.
Published Online: July 17, 2008
... membranes. 29 01 2008 08 05 2008 17 07 2008 alumina ceramics coolants maintenance engineering membranes metalworking microfiltration particle size measurement probability recycling scanning electron microscopy sintering microfiltration metalworking fluids cutting...
Journal Articles
Publisher: ASME
Article Type: Special Section: Micromanufacturing
J. Manuf. Sci. Eng. June 2008, 130(3): 031118.
Published Online: June 12, 2008
.... 13 10 2006 22 01 2007 12 06 2008 cutting milling micromachining sprays drops aerodynamics milling machines cutting tools coolants Micromachining, in particular, micromilling and microdrilling, provides both a viable and potentially preferable process to satisfy...
Topics: Cutting, Fluids
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Manuf. Sci. Eng. August 2004, 126(3): 445–450.
Published Online: September 7, 2004
... decreases in drilling forces and temperature. Additionally, increasing dilutant hardness decreased microfiltration flux, but this effect can be counteracted with the addition of a chelating agent. metalworking lubrication drilling hardness hardness testing water lubricants coolants filtration...
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Manuf. Sci. Eng. August 2004, 126(3): 451–458.
Published Online: September 7, 2004
... the need for in-line dressing steps 1 . Electroplated grinding wheels can have extraordinarily long life, provided they are utilized in manufacturing conditions (machine settings, temperature control, coolant type, fluid delivery, etc.) that are optimized for longevity of the tool. The high cost of CBN...
Journal Articles
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Manuf. Sci. Eng. August 2004, 126(3): 435–444.
Published Online: September 7, 2004
... September 2002 07 09 2004 metalworking coolants lubricants microemulsions filtration membranes particle size scanning electron microscopy recycling Sustainable aqueous systems minimize life cycle environmental impact by 1) minimizing the materials, energy, and toxicity of system...