1-6 of 6
Keywords: plastics
Close
Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Journal Articles
Article Type: Research Papers
J. Manuf. Sci. Eng. February 2010, 132(1): 011007.
Published Online: January 7, 2010
...S. J. Furst; T. A. Dow; K. Garrard; A. Sohn Centering a part on a spindle for precision machining is a tedious, time-consuming task. Currently, a skilled operator must measure the run-out of a part using a displacement gauge, then tap the part into place using a plastic or rubber hammer. This paper...
Journal Articles
Article Type: Research Papers
J. Manuf. Sci. Eng. October 2007, 129(5): 849–858.
Published Online: April 17, 2007
... melting to occur in both materials. Regardless of the apparent uniformity of the joined surfaces, microscopic roughness will exist that impedes the heat conduction ( 12 ). Understanding this impedance is critical for modeling. 31 05 2006 17 04 2007 plastics laser beam welding...
Journal Articles
Article Type: Technical Papers
J. Manuf. Sci. Eng. May 2005, 127(2): 402–410.
Published Online: April 25, 2005
... in the JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING . Manuscript received July 9, 2003; revised May 5, 2004. Associate Editor: S. R. Schmid. 09 July 2003 05 May 2004 25 04 2005 polymer blends recycling injection moulding plastics tensile strength plastics industry...
Journal Articles
Article Type: Technical Papers
J. Manuf. Sci. Eng. February 2002, 124(1): 32–41.
Published Online: December 1, 2000
...D. Arola; M. B. Sultan; M. Ramulu A finite element model was developed to simulate chip formation in the edge trimming of unidirectional Fiber Reinforced Plastics (FRPs) with orthogonal cutting tools. Fiber orientations (θ) within the range of 0 deg⩽θ⩽90 deg were considered and the cutting tool...
Journal Articles
Article Type: Technical Papers
J. Manuf. Sci. Eng. November 2000, 122(4): 698–705.
Published Online: December 1, 1999
... for a better simulation of the postfilling stage. The effect of interface gap formation between the plastic and the mold on the contact resistance is also studied. This shows that the gap may have contributed to the high magnitude of TCR reported from the one experimental study of TCR in injection molding...
Journal Articles
Article Type: Technical Papers
J. Manuf. Sci. Eng. February 2000, 122(1): 253–261.
Published Online: April 1, 1999
...P. Groombridge; A. Oloyede; E. Siores, Executive Director, This paper discusses a control system for microwave processing of materials. Microwave joining of ceramics and drying of timber are currently industry practices while microwave joining of engineering plastics and curing of epoxy adhesives...