Abstract

Electrified propulsion holds the promise of reducing aviation’s CO2 emissions footprint through three means: access to green grid electric energy, improvements in aircraft performance through new airframe and propulsion system architectures and enabling further optimization of the gas turbine cycle. Charging an aircraft battery pack with green electric energy and using this energy to drive electric propulsors results in a zero emissions vehicle. This is practical for light aircraft and short missions. Boosting a Jet-A burning gas turbine with green electric energy (again stored in a ground charged battery), in either a parallel or series turbo-electric architecture can yield a net reduction in CO2 emissions, as long as the fuel burn required to carry the weight of a discharged battery pack does not overcome the reduction in fuel burn afforded by the ground charged battery. Several studies have indicated that a net savings is possible with cell level energy densities approach ∼ 500 whr/kg, a reasonable target for the 2030 time frame. Electrified propulsion can also enable unique aircraft configurations, employing a veryhigh efficiency prime mover (gas turbine) designed for running only a generator at peak efficiency, and/or distributing the propulsors throughout the aircraft, for improvement in L/D and propulsive efficiency.

References

1.
National Academies of Sciences, Engineering, and Medicine
.
2016
,
Commercial Aircraft Propulsion and Energy Systems Research: Reducing Global Carbon Emissions
.
The National Academies Press
.
Washington, DC
: .
2.
Advanced Research Projects Agency - Energy (ARPA-E) Funding Opportunity Announcement
,
“Range Extenders for Electric Aviation with Low Carbon and High Efficiency (REEACH)“
, .
3.
Borer
,
N.K.
et. al.,
2016
,
“Design and Performance of the NASA SCEPTOR Distributed Electric Propulsion Flight Demonstrator“
,
AIAA AVIATION Forum, AIAA 2016-3920
,
Washington, D.C
,.
4.
Epstein
,
A.
,
O’Flarity
,
S.
,
“Considerations for Reducing Aviation’s CO2 with Aircraft Electric Propulsion“
,
Journal of Propulsion and Power
, .
5.
Liu
,
J.
, et. al., (
2019
)
“Pathways for practical high-energy long-cycling lithium metal batteries”
,
Nature Energy
4
,
March
180
186
.
6.
Bradley
,
M.K.
, and
Droney
,
C.K.
,
2012
,
“Subsonic Ultra Green Aircraft Research Phase II: N+4 Advanced Concept Development”
,
National Aeronautics and Space Administration Contractor Report NASA/CR-2012-217556
.
7.
Lents
,
C.E.
,
Hardin
,
L.W.
,
2019
,
“Fuel Burn and Energy Consumption Reductions of a Single-Aisle Class Parallel Hybrid Propulsion System”
,
AIAA Electric Aircraft Technology Symposium
, .
8.
Gladin
,
J.C.
, et al,
2018
,
“Fundamentals of Parallel Hybrid Turbofan Mission Analysis with Application to the Electrically Variable Engine”
,
AIAA/IEE 2018 Electric Aircraft Technology Symposium, Cincinnati OH
.
9.
Culley
,
D.E.
,
Kratz
,
J.L.
,
Thomas
,
G.L.
,
2018
,
“Turbine Electrified Energy Management (TEEM) For Enabling More Efficient Engine Designs“
,
AIAA Propulsion and Energy Forum, AIAA 2018-4798, Cincinnati OH
.
10.
Jansen
,
R.H.
,
Brown
,
G.V
,
Felder
,
J.L.
, and
Duffy
,
K.P
,
2015
,
“Turboelectric Aircraft Drive Key Performance Parameters and Functional Requirements,“
AIAA Propulsion and Energy Forum, AIAA 2015-3890, Orlando FL
.
11.
Jansen
,
R.H.
,
Duffy
,
K.R.
and
Brown
,
G.V.
,
2017
,
“Partially Turboelectric Aircraft Drive Key Performance Parameters,“
AIAA Propulsion and Energy Forum, AIAA 2017-4702, Atlanta GA
.
12.
Isikveren
,
A.
,
Kaiser
,
S.
,
Pomet
,
C.
,
Vratny
,
P.C.
,
2014
,
“Per-design Strategies and Sizing Techniques for Dual-Energy Aircraft”
,
Aircraft Engineering and Aerospace Technology: An International Journal
.
You do not currently have access to this content.