Abstract
This study presents the geometrical optimization of a solar air heater. A reasonable working range of geometrical parameters: length 1–3 m, width 0.1–0.5 m, and height 0.005–0.05 m (or aspect ratio 1–20), is investigated as per general applications and installation constraints. The effect of these geometrical parameters on thermal (heat flux and outlet air temperature) and hydraulic (air velocity, mass flowrate, pressure loss and pumping power, and Bejan number) parameters are theoretically studied. Later, a numerical investigation is carried out with an optimum geometry of SAH-duct (length 2.44 mm and width 0.3 m), for aspect ratio 4–18 and Re 3000–15,000. An experimental study is also done to validate numerical results. The heat transfer and frictional loss do not show a significant change in the values for the aspect ratio 8–12.
Issue Section:
Research Papers
References
1.
Chhaparwal
, G.
, Srivastava
, A.
, and Dayal
, R.
, 2019
, “Artificial Repeated-Rib Roughness in a Solar Air Heater – A Review
,” Sol. Energy
, 194
, pp. 329
–359
. 10.1016/j.solener.2019.10.0112.
Charters
, W. W.
, 1971
, “Some Aspects of Flow Duct Design for Solar-Air Heater Applications
,” Sol. Energy
, 13
(2
), pp. 283
–288
. 10.1016/0038-092X(71)90009-03.
Hollands
, K. G. T.
, and Shewen
, E. C.
, 1981
, “Optimization of Flow Passage Geometry for Air-Heating, Plate-Type Solar Collectors
,” ASME J. Sol. Energy Eng.
, 103
(4
), p. 323
. 10.1115/1.32662604.
Bhargava
, A. K.
, Garg
, H. P.
, and Sharma
, V. K.
, 1982
, “Theoretical Analysis of Some Configurations of Double Exposure Solar Air Heaters
,” Energy
, 7
(4
), pp. 377
–388
. 10.1016/0360-5442(82)90097-45.
Husain
, M. S.
, Tiwari
, G. N.
, and Garg
, H. P.
, 1985
, “Performance of a Solar Collector/Storage Water Heater
,” Appl. Energy
, 20
(4
), pp. 301
–316
. 10.1016/0306-2619(85)90020-06.
Rohsenow
, W. M.
, Hartnett
, J. R.
, and Cho
, Y. I.
, 1998
, Handbook of Heat Transfer
, 3rd ed., McGraw-Hill Education
, New York
, pp. 1
–1520
.7.
Hartnet
, J. P.
, and Irvine
, T. F.
, Jr., 1957
, “Nusselt Values for Estimating Liquid Metal Heat Transfer in Noncircular Ducts
,” AIChE J.
, 3
(3
), pp. 313
–317
. 10.1002/aic.6900303058.
Jones
, O. C.
, 1976
, “An Improvement in the Calculation of Turbulent Friction in Rectangular Ducts
,” ASME J. Fluids Eng.
, 98
(2
), pp. 173
–181
. 10.1115/1.34482509.
Murata
, A.
, and Mochizuki
, S.
, 1999
, “Effect of Cross-Sectional Aspect Ratio on Turbulent Heat Transfer in An Orthogonally Rotating Rectangular Smooth Duct
,” Int. J. Heat Mass Transfer
, 42
(20
), pp. 3803
–3814
. 10.1016/S0017-9310(99)00058-710.
Chang
, M. Y.
, and Lin
, T. F.
, 1998
, “Experimental Study of Aspect Ratio Effects on Longitudinal Vortex Flow in Mixed Convection of Air in a Horizontal Rectangular Duct
,” Int. J. Heat Mass Transf.
, 41
(4–5
), pp. 719
–733
. 10.1016/S0017-9310(97)00165-811.
Chang
, S. W.
, Chiang
, K. F.
, and Lin
, C. Y.
, 2014
, “Channel Aspect Ratio Effect on Thermal Performance of Air-Water Slug Flow Through U-Bend Channels
,” Int. J. Therm. Sci.
, 76
, pp. 11
–29
. 10.1016/j.ijthermalsci.2013.08.00912.
Etemad
, S.
, and Mujumdar
, A. S.
, 1994
, “The Effect of Aspect Ratio and Rounded Corners on the Laminar Forced Convection Heat Transfer of a Non Newtonian Fluid in the Entrance Region of a Rectangular Duct
,” Int. Commun. Heat Mass Transf.
, 21
(2
), pp. 283
–296
. 10.1016/0735-1933(94)90026-413.
Han
, J.-C.
, and Park
, J. S.
, 1988
, “Developing Heat Transfer in Rectangular Channels With Rib Tubulators
,” Int. J. Heat Mass Transf.
, 31
(1
), pp. 183
–195
. 10.1016/0017-9310(88)90235-914.
Choi
, H. S.
, and Park
, T. S.
, 2013
, “The Influence of Streamwise Vortices on Turbulent Heat Transfer in Rectangular Ducts with Various Aspect Ratios
,” Int. J. Heat Fluid Flow
, 40
, pp. 1
–14
. 10.1016/j.ijheatfluidflow.2012.12.00315.
Lee
, P. S.
, and Garimella
, S. V.
, 2006
, “Thermally Developing Flow and Heat Transfer in Rectangular Microchannels of Different Aspect Ratios
,” Int. J. Heat Mass Transf.
, 49
(17–18
), pp. 3060
–3067
. 10.1016/j.ijheatmasstransfer.2006.02.01116.
Schmidt
, F. W.
, 1971
, “Private Communication,” Tech. Rep
., Pennsylvania State University
, University Park, PA
.17.
Shah
, R. K.
, and London
, A. L.
, 1971
, “Laminar Flow Forced Convection Heat Transfer and Flow Friction in Straight and Curved Ducts A Summary of Analytical Solutions,” Tech. Rep
., Technical Report No. 75
, Stanford University
, Stanford, CA
.18.
ANSYS, Inc.
, 2013
, ANSYS Fluent Theory Guide
, Vol. 80
, Canonsburg, PA.19.
ANSI/ASHRAE Standard 93-2010 (RA 2014)
, Methods of Testing to Determine the Thermal Performance of Solar Collectors
.Copyright © 2020 by ASME
You do not currently have access to this content.
