The object of this paper will be to optimize the contact stiffness (CS) of an existing proximity recording air bearing surface (ABS). The CS is a measure of the slider’s increase in contact force with increase in slider/disk interference. By minimizing this, the amount of force transmitted through the slider at the interface is minimized. This should, in turn, minimize the amount of wear, improving the tribological performance. Comparisons of the pre- and post-optimized slider have been made. In combination with research that demonstrates the ability of the CS parameter to predict tribological behavior (Hu et al., ASME J. Tribol., 120, pp. 272–279) this paper demonstrates the feasibility of numerical optimization of the tribological behavior of proximity recording air bearing sliders. [S0742-4787(00)03201-X]
Skip Nav Destination
Article navigation
January 2000
Technical Papers
Optimization of Proximity Recording Air Bearing Sliders in Magnetic Hard Disk Drives
Matthew A. O’Hara,
Matthew A. O’Hara
Maxtor Corporation, Milpitas, CA 95035
Search for other works by this author on:
David B. Bogy, William S. Floyd, Jr. Distinguished Professor in Engineering, Fellow ASME
David B. Bogy, William S. Floyd, Jr. Distinguished Professor in Engineering, Fellow ASME
Computer Mechanics Laboratory, Department of Mechanical Engineering, University of California, Berkeley, CA 94720
Search for other works by this author on:
Matthew A. O’Hara
Maxtor Corporation, Milpitas, CA 95035
Yong Hu
Quinta Corporation, San Jose, CA 95131
David B. Bogy, William S. Floyd, Jr. Distinguished Professor in Engineering, Fellow ASME
Computer Mechanics Laboratory, Department of Mechanical Engineering, University of California, Berkeley, CA 94720
Contributed by the Tribology Division for publication in the JOURNAL OF TRIBOLOGY. Manuscript received by the Tribology Division January 14, 1999; revised manuscript received June 8, 1999. Associate Technical Editor: A. K. Menon.
J. Tribol. Jan 2000, 122(1): 257-259 (3 pages)
Published Online: June 8, 1999
Article history
Received:
January 14, 1999
Revised:
June 8, 1999
Citation
O’Hara , M. A., Hu , Y., and Bogy , D. B. (June 8, 1999). "Optimization of Proximity Recording Air Bearing Sliders in Magnetic Hard Disk Drives ." ASME. J. Tribol. January 2000; 122(1): 257–259. https://doi.org/10.1115/1.555350
Download citation file:
Get Email Alerts
Related Articles
Discussion: “Analysis of Stresses Induced by Dynamic Load Head-Disk Contacts” (Fu, Ra-Chang and Bogy, David B., 2000, ASME J. Tribology, 122 , No. 1, pp. 233–237)
J. Tribol (July,2001)
Effects of Moving Three-Dimensional Nano-Textured Disk Surfaces on Thin Film Gas Lubrication Characteristics for Flying Head Slider Bearings in Magnetic Disk Storage
J. Tribol (January,2001)
Analysis of Bouncing Vibrations of a 2-DOF Model of Tripad Contact Slider Over a Random Wavy Disk Surface
J. Tribol (January,2001)
On the Thermal Behavior of Giant Magnetoresistance Heads
J. Tribol (April,2001)
Related Chapters
Numerical Simulation of the Air Bearing Film in the Head-Disk Interface of Hard Disk Drives by Using Meshless Locall Petrov-Galerkin Method
International Conference on Mechanical and Electrical Technology 2009 (ICMET 2009)
Tribology in the Past and in the Future
Tribology of Mechanical Systems: A Guide to Present and Future Technologies
Some Recent Advances and Current Challenges in Joint-Replacement Tribology and UHMWPE Bearing Surfaces
Tribology of Mechanical Systems: A Guide to Present and Future Technologies