The steady-state described by running-in attractor in the perspective of nonlinearity, is closely dependent on the running-in parameters. To study the dependence of running-in attractor on system parameters, pin-on-disk friction tests were performed. A suitable contact between pin and disk was ensured by a self-adaptive pin holder, standard block, and self-adapting amendment with sandpaper. Range analysis of correlation dimension, predictability, and entropy shows that running-in attractor is system dependent, which is manifested by the dependence of nonlinear parameters of the attractor on the running-in parameters. Further results indicate that the correlation dimension and entropy increase with load and velocity, but decrease along with initial roughness of a harder counterface, and predictability shows an inverse variation tendency with correlation dimension and entropy.
Issue Section:
Friction and Wear
References
1.
Xie
, Y. B.
, 2001
, “Three Axioms in Tribology
,” Tribol.
, 21
(3
), pp. 161
–166
(in Chinese).2.
Xie
, Y. B.
, 1999
, “On the Tribology Design
,” Tribol. Int.
, 32
(7
), pp. 351
–358
.3.
Frąś
, T.
, Rusinek
, A.
, Pęcherski
, R. B.
, Bernier
, R.
, and Jankowiak
, T.
, 2014
, “Analysis of Friction Influence on Material Deformation Under Biaxial Compression State
,” Tribol. Int.
, 80
, pp. 14
–24
.4.
Podgursky
, V.
, Adoberg
, E.
, Surženkov
, A.
, Kimmari
, E.
, Viljus
, M.
, Hartelt
, M.
, Wasche
, R.
, Sima
, M.
, and Kulu
, P.
, 2011
, “Dependence of the Friction Coefficient on Roughness Parameters During Early Stage Fretting of (Al, Ti)N Coated Surfaces
,” Wear
, 271
(5–6
), pp. 853
–858
.5.
Bucholz
, E. W.
, Kong
, C. S.
, Marchman
, K. R.
, Sawyer
, W. G.
, Phillpot
, S. R.
, Sinnott
, S. B.
, and Rajan
, K.
, 2012
, “Data-Driven Model for Estimation of Friction Coefficient Via Informatics Methods
,” Tribol. Lett.
, 47
(2
), pp. 211
–221
.6.
Rosenkranz
, A.
, Pangraz
, J. C.
, Gachot
, C.
, and Mucklich
, F.
, 2016
, “Load-Dependent Run-In and Wear Behaviour of Line-Like Surface Patterns Produced by Direct Laser Interference Patterning
,” Wear
, 368–369
, pp. 350
–357
.7.
Kumar
, R.
, Prakash
, B.
, and Sethuramiah
, A.
, 2002
, “A Systematic Methodology to Characterize the Running-In and Steady-State Wear Processes
,” Wear
, 252
(5–6
), pp. 445
–453
.8.
Akbarzadeh
, S.
, and Khonsari
, M. M.
, 2011
, “Experimental and Theoretical Investigation of Running-In
,” Tribol. Int.
, 44
(2
), pp. 92
–100
.9.
Wagner
, J. J.
, Jenson
, A. D.
, and Sundararajan
, S.
, 2017
, “The Effect of Contact Pressure and Surface Texture on Running-In Behavior of Case Carburized Steel Under Boundary Lubrication
,” Wear
, 376–377
(Pt. A
), pp. 851
–857
.10.
Hanief
, M.
, and Wani
, M. F.
, 2016
, “Effect of Surface Roughness on Wear Rate During Running-In of En31-Steel: Model and Experimental Validation
,” Mater. Lett.
, 176
, pp. 91
–93
.11.
Lu
, W. L.
, Zhang
, G. P.
, Liu
, X. J.
, Zhou
, L. P.
, Chen
, L. Z.
, and Jiang
, X. Q.
, 2014
, “Prediction of Surface Topography at the End of Sliding Running-In Wear Based on Areal Surface Parameters
,” Tribol. Trans.
, 57
(3
), pp. 553
–560
.12.
Blau
, P. J.
, 1989
, Friction and Wear Transitions of Materials
, Noyes Publications
, Park Ridge, NJ
.13.
Fox-Rabinovich
, G. S.
, Gershman
, I. S.
, Yamamoto
, K.
, Biksa
, A.
, Veldhuis
, S. C.
, Beake
, B. D.
, and Kovalev
, A. I.
, 2010
, “Self-Organization During Friction in Complex Surface Engineered Tribosystems
,” Entropy
, 12
(12
), pp. 275
–288
.14.
Mortazavi
, V.
, Menezes
, P. L.
, and Nosonovsky
, M.
, 2011
, “Studies of Shannon Entropy Evolution Due to Self-Organization During the Running-In
,” ASME
Paper No. IJTC2011-61231.15.
Ding
, C.
, Zhu
, H.
, Sun
, G.
, Zhou
, Y. K.
, and Zuo
, X.
, 2017
, “Chaotic Characteristics and Attractor Evolution of Friction Noise During Friction Process
,” Friction
, 6
(1
), pp. 47
–61
.16.
Zhou
, Y. K.
, Zhu
, H.
, Zuo
, X.
, Li
, Y.
, and Chen
, N. X.
, 2015
, “The Nonlinear Nature of Friction Coefficient in Lubricated Sliding Friction
,” Tribol. Int.
, 88
, pp. 8
–16
.17.
Zhou
, Y. K.
, Zhu
, H.
, Zuo
, X.
, and Yang
, J. H.
, 2014
, “Chaotic Characteristics of Measured Temperatures During Sliding Friction
,” Wear
, 317
(1–2
), pp. 17
–25
.18.
Zuo
, X.
, Zhu
, H.
, Zhou
, Y. K.
, and Ding
, C.
, 2015
, “Monofractal and Multifractal Behavior of Worn Surface in Brass-Steel Tribosystem Under Mixed Lubricated Condition
,” Tribol. Int.
, 93
(Pt. A
), pp. 306
–317
.19.
Zhu
, H.
, Zuo
, X.
, and Zhou
, Y. K.
, 2016
, “Recurrence Evolvement of Brass Surface Profile in Lubricated Wear Process
,” Wear
, 352–353
, pp. 9
–17
.20.
Zhu
, H.
, Ge
, S. R.
, Lv
, L.
, and Lu
, B. B.
, 2008
, “Evolvement Rule of Running-in Attractor
,” Chin. J. Mech. Eng.
, 44
(03
), pp. 99
–104
.21.
Zhou
, Y. K.
, Zhu
, H.
, and Zuo
, X.
, 2016
, “The Behavior of Intrinsic Randomness and Dynamic Abrupt Changes of Friction Force Signal During the Friction Process
,” ASME J. Tribol.
, 138
(3
), p. 031605
.22.
Galatolo
, S.
, 2003
, “Complexity, Initial Condition Sensitivity, Dimension and Weak Chaos in Dynamical Systems
,” Nonlinearity
, 16
(4
), pp. 12
–19
.23.
Grassberger
, P.
, and Procaccia
, I.
, 1983
, “Characterization of Strange Attractors
,” Phys. Rev. Lett.
, 50
(5
), pp. 346
–349
.24.
Manuca
, R.
, and Savit
, R.
, 1996
, “Stationarity and Nonstationarity in Time Series Analysis
,” Physica D
, 99
(2–3
), pp. 134
–161
.25.
Nosonovsky
, M.
, 2010
, “Entropy in Tribology: In the Search for Applications
,” Entropy
, 12
(12
), pp. 1345
–1390
.26.
Blau
, P. J.
, 2005
, “On the Nature of Running-In
,” Tribol. Int.
, 38
(11–12
), pp. 1007
–1012
.27.
Zhou
, Y. K.
, Zhu
, H.
, and Zuo
, X.
, 2016
, “Dynamic Evolutionary Consistency Between Friction Force and Friction Temperature From the Perspective of Morphology and Structure of Phase Trajectory
,” Tribol. Int.
, 94
, pp. 606
–615
.28.
Grassberger
, P.
, and Procaccia
, I.
, 1983
, “Estimation of the Kolmogorov Entropy From a Chaotic Signal
,” Phys. Rev. A
, 28
(4
), pp. 2591
–2593
.Copyright © 2018 by ASME
You do not currently have access to this content.
