Skip Nav Destination
Issues
October 1995
ISSN 0742-4787
EISSN 1528-8897
In this Issue
Research Papers
Friction Characteristics and Adhesion Force Under Low Normal Load
J. Tribol. October 1995, 117(4): 569–574.
doi: https://doi.org/10.1115/1.2831515
Numerical Simulations of Slider Interaction With Multiple Asperity Using Hertzian Contact Model
J. Tribol. October 1995, 117(4): 575–579.
doi: https://doi.org/10.1115/1.2831518
Topics:
Computer simulation
,
Disks
,
Surface roughness
,
Dynamics (Mechanics)
,
Friction
,
Impulse (Physics)
,
Momentum
,
Simulation results
Pole Tip Recession: Investigation of Factors Affecting Its Measurement and Its Variation With Contact Start-Stop and Constant Speed Drag Testing
J. Tribol. October 1995, 117(4): 580–587.
doi: https://doi.org/10.1115/1.2831519
Topics:
Drag (Fluid dynamics)
,
Poles (Building)
,
Testing
,
Atomic force microscopy
,
Interferometry
,
Air bearings
,
Cycles
,
Magnification
Design Optimization of the Taper-Flat Slider Positioned by a Rotary Actuator
J. Tribol. October 1995, 117(4): 588–593.
doi: https://doi.org/10.1115/1.2831520
Topics:
Actuators
,
Design
,
Optimization
,
Air bearings
,
Magnetic recording
,
Rails
Nanoscale Indentation Hardness and Wear Characterization of Hydrogenated Carbon Thin Films
J. Tribol. October 1995, 117(4): 594–601.
doi: https://doi.org/10.1115/1.2831521
Topics:
Carbon
,
Nanoscale phenomena
,
Thin films
,
Wear
,
Stress
,
Film thickness
,
Carbon films
,
Deformation
,
Nanoindentation
,
Atomic force microscopy
Numerical Simulation of Head-Disk Impacts During Dynamic Loading Processes
J. Tribol. October 1995, 117(4): 602–606.
doi: https://doi.org/10.1115/1.2831522
Accurate Real Area of Contact Measurements on Polyurethane
J. Tribol. October 1995, 117(4): 607–611.
doi: https://doi.org/10.1115/1.2831523
Topics:
Urethane elastomers
,
Stress
,
Surface roughness
,
Glass
,
Reliability
Wear Resistance of N+-Implanted Silicon Investigated by Scanning Probe Microscopy
J. Tribol. October 1995, 117(4): 612–616.
doi: https://doi.org/10.1115/1.2831524
A Correlation Between Low Cycle Fatigue Properties and Scuffing Properties of 4340 Steel
J. Tribol. October 1995, 117(4): 617–621.
doi: https://doi.org/10.1115/1.2831525
Topics:
Low cycle fatigue
,
Steel
,
Lubricants
,
Mineral oil
,
Tensile strength
Effect of Thermal Distortion on Wear of Composites
J. Tribol. October 1995, 117(4): 622–628.
doi: https://doi.org/10.1115/1.2831526
Topics:
Composite materials
,
Wear
,
Deformation
,
Friction
,
Heating
,
Metals
,
Numerical analysis
,
Oxide ceramics
,
Pressure
,
Traction
Tribological Behavior of Cubic Boron Nitride Film Sliding Against Diamond
J. Tribol. October 1995, 117(4): 629–633.
doi: https://doi.org/10.1115/1.2831527
Topics:
Boron
,
Diamonds
,
Tribology
,
Stress
,
Friction
,
Plasmas (Ionized gases)
,
Wear
,
Magnetic fields
,
Plating
,
Silicon
Dust Generation From Rolling-Sliding Elements of Combined Stainless Steel and Silicon Nitride
J. Tribol. October 1995, 117(4): 634–638.
doi: https://doi.org/10.1115/1.2831528
Topics:
Dust
,
Silicon nitride ceramics
,
Stainless steel
,
Wear
,
Friction
,
Lubricants
,
Lubrication
,
Testing
,
Tribology
Rating Thread Compounds for Galling Resistance
J. Tribol. October 1995, 117(4): 639–645.
doi: https://doi.org/10.1115/1.2831529
Topics:
Galling
,
Thread
,
Tubing
,
Failure
,
Lithium
,
Stress
,
American Petroleum Institute
,
Engineering standards
,
Friction
,
Oil fields
Thermal Non-Newtonian EHL Analysis of Rib-Roller End Contact in Tapered Roller Bearings
J. Tribol. October 1995, 117(4): 646–654.
doi: https://doi.org/10.1115/1.2831530
Topics:
Rollers
,
Tapered roller bearings
,
Lubricants
,
Temperature
,
Film thickness
,
Friction
,
Kinematics
,
Stress
,
Temperature effects
,
Torque
Influence of Indent Geometry on Repeated Two-Dimensional Rolling Contact
J. Tribol. October 1995, 117(4): 655–659.
doi: https://doi.org/10.1115/1.2831531
Topics:
Geometry
,
Rolling contact
,
Pressure
,
Coatings
,
Design
,
Finite element analysis
,
Finite element model
,
Stress
,
Surface properties
Contribution of Surface Irregularities to Rolling Contact Plasticity in Bearing Steels
J. Tribol. October 1995, 117(4): 660–666.
doi: https://doi.org/10.1115/1.2831532
Topics:
Bearings
,
Plasticity
,
Rolling contact
,
Steel
,
Deformation
,
Constitutive equations
,
Pressure
,
Finite element model
,
Hardening
,
Kinematics
Model-Based Investigation of Friction During Start-Up of Hydrodynamic Journal Bearings
J. Tribol. October 1995, 117(4): 667–673.
doi: https://doi.org/10.1115/1.2831533
Topics:
Friction
,
Journal bearings
,
Bearings
,
Design
,
Displacement
,
Dynamic systems
,
Lubrication
,
Rotors
,
Sliding friction
,
Stick-slip
A Method of Friction Torque Measurement for a Hydrodynamic Thrust Bearing
J. Tribol. October 1995, 117(4): 674–678.
doi: https://doi.org/10.1115/1.2831534
Topics:
Friction
,
Thrust bearings
,
Torque measurement
,
Design
,
Stress
,
Torque
,
Torquemeters
,
Bearings
,
Calibration
,
Drag (Fluid dynamics)
The Importance of Traction in Web Handling
J. Tribol. October 1995, 117(4): 679–684.
doi: https://doi.org/10.1115/1.2831535
Topics:
Traction
,
Friction
,
Rollers
,
Surface roughness
Inertia Effects on Film Rupture in Hydrodynamic Lubrication
J. Tribol. October 1995, 117(4): 685–690.
doi: https://doi.org/10.1115/1.2831536
Topics:
Inertia (Mechanics)
,
Lubrication
,
Rupture
,
Bearings
,
Boundary-value problems
,
Bubbles
,
Cylinders
,
Lubricants
,
Waves
Stability of Rough Journal Bearings Using Nonlinear Transient Method
J. Tribol. October 1995, 117(4): 691–695.
doi: https://doi.org/10.1115/1.2831538
Topics:
Journal bearings
,
Stability
,
Surface roughness
,
Transients (Dynamics)
,
Composite materials
,
Rotors
,
Shear flow
Measurement of Oil Film Journal Bearing Damping Coefficients—An Extension of the Selected Orbit Technique
J. Tribol. October 1995, 117(4): 696–701.
doi: https://doi.org/10.1115/1.2831539
Topics:
Damping
,
Journal bearings
,
Uncertainty
,
Uncertainty analysis
A High Performance Journal Bearing With Controlled Elastic Deflection
J. Tribol. October 1995, 117(4): 702–708.
doi: https://doi.org/10.1115/1.2831540
Topics:
Deflection
,
Journal bearings
,
Bearings
,
Elasticity
,
Friction
,
Load bearing capacity
,
Pressure
,
Temperature
,
Temperature effects
,
Viscosity
Journal Orbits and Their Stability for Rigid Unbalanced Rotors
J. Tribol. October 1995, 117(4): 709–716.
doi: https://doi.org/10.1115/1.2831541
Topics:
Rotors
,
Stability
,
Bearings
,
Equations of motion
,
Journal bearings
,
Symmetry (Physics)
Misalignment Effect on the Static and Dynamic Characteristics of Hydrodynamic Journal Bearings
J. Tribol. October 1995, 117(4): 717–723.
doi: https://doi.org/10.1115/1.2831542
Topics:
Bearings
,
Finite difference methods
,
Flow (Dynamics)
,
Friction
,
Journal bearings
,
Rotors
,
Stability
,
Stress
Magnetohydrodynamic Braking
J. Tribol. October 1995, 117(4): 724–728.
doi: https://doi.org/10.1115/1.2831543
Topics:
Braking
,
Magnetohydrodynamics
,
Magnetic fields
,
Plates (structures)
,
Fluids
Finite Element Analysis of Rolling Contact for Nonlinear Kinematic Hardening Bearing Steel
J. Tribol. October 1995, 117(4): 729–736.
doi: https://doi.org/10.1115/1.2831544
Topics:
Bearing steel
,
Finite element analysis
,
Hardening
,
Kinematics
,
Rolling contact
,
Deformation
,
Etching
,
Finite element model
,
Fracture (Materials)
,
Pressure
Effect of Humidity on the Friction and Wear Properties of Sn
J. Tribol. October 1995, 117(4): 737–741.
doi: https://doi.org/10.1115/1.2831545
Errata
Erratum: “Boundary and Mixed Friction in the Presence of Dynamic Normal Loads: Part II—Friction Transients” [1995, ASME Journal of Tribology, 117(2), pp. 261–266]
J. Tribol. October 1995, 117(4): 574.
doi: https://doi.org/10.1115/1.2831517
Topics:
Friction
,
Stress
,
Transients (Dynamics)
,
Tribology
Technical Briefs
Design Procedure for Evaluating Stability of Turbomachinery Supported on Squeeze Film Dampers
J. Tribol. October 1995, 117(4): 742–744.
doi: https://doi.org/10.1115/1.2831546
Topics:
Dampers
,
Design
,
Stability
,
Turbomachinery
On the Modeling of a Thermomechanical Seizure
J. Tribol. October 1995, 117(4): 744–747.
doi: https://doi.org/10.1115/1.2831547
Topics:
Modeling
,
Thermomechanics
Discussions
Discussion: “Boundary and Mixed Friction in the Presence of Dynamic Normal Loads: Part II—Friction Transients” (Polycarpou, A. A., and Soom, A. A., 1995, ASME J. Tribol., 117, pp. 261–266)
J. Tribol. October 1995, 117(4): 748.
doi: https://doi.org/10.1115/1.2831548
Topics:
Friction
,
Stress
,
Transients (Dynamics)
Email alerts
RSS Feeds
Tribological Behavior of Annealed FeCoNiMn0.25Al0.25 High-Entropy Alloy
J. Tribol (November 2025)
Friction Reduction and Lubrication Performance of New Microemulsion Cutting Fluid for AISI 1045
J. Tribol (December 2025)
Friction and Wear Behaviors of HT200 Sliding Against QT600 Under Flame Ablation Environment
J. Tribol (December 2025)