An experimental and numerical study was performed on an optimized compressor stator cascade designed to operate efficiently at high inlet Mach numbers ranging from 0.83 to 0.93 (higher supercritical flow conditions). Linear cascade tests confirmed that low losses and high turning were achieved at normal supercritical flow conditions , as well as higher supercritical flow conditions , both at design and off-design incidences. The performance of this optimized stator cascade is better than those reported in the literature based on Double Circular Arc (DCA) and Controlled Diffusion Airfoil (CDA) blades, where losses increase rapidly for . A two-dimensional (2D) Navier-Stokes solver was applied to the cascade to characterize the performance and flow behavior. Good agreement was obtained between the CFD and the experiment. Experimental loss characteristics, blade surface Mach numbers, shadowgraphs, along with CFD flowfield simulations, were presented to elucidate the flow physics. It is found that low losses are due to the well-controlled boundary layer, which is attributed to an optimum flow structure associated with the blade profile. The multishock pattern and the advantageous pressure gradient distribution on the blade are the key reasons of keeping the boundary layer from separating, which in turn accounts for the low losses at the higher supercritical flow conditions.
Skip Nav Destination
Article navigation
July 2006
Technical Papers
Performance and Flow Characteristics of an Optimized Supercritical Compressor Stator Cascade
Bo Song,
Bo Song
Department of Mechanical Engineering,
Virginia Polytechnic Institute and State University
, Blacksburg, VA 24061
Search for other works by this author on:
Wing F. Ng
Wing F. Ng
Department of Mechanical Engineering,
Virginia Polytechnic Institute and State University
, Blacksburg, VA 24061
Search for other works by this author on:
Bo Song
Department of Mechanical Engineering,
Virginia Polytechnic Institute and State University
, Blacksburg, VA 24061
Wing F. Ng
Department of Mechanical Engineering,
Virginia Polytechnic Institute and State University
, Blacksburg, VA 24061J. Turbomach. Jul 2006, 128(3): 435-443 (9 pages)
Published Online: February 1, 2005
Article history
Received:
October 1, 2004
Revised:
February 1, 2005
Citation
Song, B., and Ng, W. F. (February 1, 2005). "Performance and Flow Characteristics of an Optimized Supercritical Compressor Stator Cascade." ASME. J. Turbomach. July 2006; 128(3): 435–443. https://doi.org/10.1115/1.2183316
Download citation file:
Get Email Alerts
A Digital Engineering Analysis of an Additively-Manufactured Turbine Vane
J. Turbomach (May 2025)
Mode Analysis for the Rotating Aerodynamic Disturbance of a Transonic Fan
J. Turbomach (May 2025)
Effect of Ceramic Matrix Composites on the Thermal Efficiency of a Power Generation Turbine
J. Turbomach (May 2025)
Heat Transfer Enhancement in Pulsating Flows: A Bayesian Approach to Experimental Correlations
J. Turbomach (May 2025)
Related Articles
Advanced High-Turning Compressor Airfoils for Low Reynolds Number Condition—Part II: Experimental and Numerical Analysis
J. Turbomach (October,2004)
Inverse Design of and Experimental Measurements in a Double-Passage Transonic Turbine Cascade Model
J. Turbomach (July,2005)
Three-Dimensional Separations in Axial Compressors
J. Turbomach (April,2005)
Related Chapters
Aerodynamic Performance Analysis
Axial-Flow Compressors
Boundary Layer Analysis
Centrifugal Compressors: A Strategy for Aerodynamic Design and Analysis
Introduction
Design and Analysis of Centrifugal Compressors